Knowde Enhanced TDS
Identification & Functionality
- Technologies
- Product Families
- Active Ingredient:
Glycerol, Sodium Xylene Sulfanate,
Alkyl Phenol Ethoxylateb- 80.0%
CONSTITUENTS INEFFECTIVE AS SPRAY ADJUVANT - 20.0%
Features & Benefits
- Agrochemicals Features
Applications & Uses
- Markets
- Applications
- Directions For Use
REFER TO PESTICIDE LABEL FOR SPECIFIC CROP USE AND APPLICATION
RATES. Mix 0.5 to 4 pints per 100 gallons of spray solution. Use enough FARM GENERAL 80/20 SURFACTANT to achieve good wetting, spreading and surface coverage without excessive runoff.
NOT FOR AQUATIC USE.
Note: The above use recommendations are considered to be adequate for most uses. Some pesticides, however, may require higher or lower rates for optimum effect. Follow the pesticide label directions when this occurs.- Mixing Instructions
Prior to any pesticide application all spray mixing and application equipment must be cleaned. Carefully observe all cleaning directions on the pesticide label. Fill spray tank one-half full with water and begin agitation. Add pesticides as directed by labeling or in the following sequence:
Regulatory & Compliance
Safety & Health
- Precautionary Statements
WARNING: Harmful if swallowed. Causes eye and skin irritation. Harmful if inhaled. If medical advice is needed, have product container or label on hand. Read label before use. Wash protective equipment and work clothes thoroughly after handling. Do not eat, drink or smoke when using this product. Avoid breathing dust, fume, gas, mist, vapors or spray. Use only outdoors or in well ventilated area. Personal Protective Equipment: Wear protective gloves, clothing, eye and face protection.
Storage & Handling
- Storage And Disposal
Do not contaminate water, food or feed by storage or disposal.
STORAGE: Keep away from heat, sparks and flame. Keep container closed. Store in a dry place between 40°F and 120°F. Partially used containers should be resealed between uses for maximum storage stability.
CONTENT DISPOSAL: Dispose of material in compliance with applicable federal, state and local environmental regulations. Recycle or rework material if at all possible. Incinerate material at an approved facility or treat at an acceptable waste treatment facility or municipal waste treatment plant after proper testing and approval of waste samples.
CONTAINER DISPOSAL: An empty container can contain product residue and should not be reused. If not professionally cleaned and reconditioned, crushing or other means is recommended to prevent unauthorized reuse. Dispose of container to disposal plant in accordance with federal, state and local regulations.