Knowde Enhanced TDS
Identification & Functionality
- Agrochemical Functions
- Technologies
- Product Families
- INGREDIENTS
ACTIVE INGREDIENT:
Chlorothalonil (tetrachloroisophthalonitrile) ............................................................................. 38.5%
OTHER INGREDIENTS: .......................................................................................................... 61.5%
TOTAL: ..................................................................................................................................... 100.0%
Contains 4.17 Pounds Chlorothalonil Per Gallon (500 grams per liter)
Applications & Uses
- Markets
- Applications
- Application Technique
- Fungicide Target Species
- DIRECTIONS FOR USE
Zinc is incorporated into this formulation as a micronutrient to provide plants with zinc required for growth.
Properties
- Physical Form
Storage & Handling
- STORAGE AND DISPOSAL
DO NOT contaminate water, food or feed by storage or disposal. Open dumping is prohibited.
Pesticide Storage: Store in a cool place. Protect from excessive heat.
Pesticide Disposal: Pesticide wastes are toxic. Improper disposal of excess pesticide, pesticide spray or rinsate is a violation of Federal law. If these wastes cannot be disposed of by use according to label instructions, contact your State Pesticide or Environmental Control Agency, or the Hazardous Waste representative at the nearest EPA Regional Office for guidance.
Container Disposal: Non-refillable Container. Do not use or refill this container. Triple rinse or pressure rinse container (or equivalent) promptly after emptying; then offer for recycling, if available, or reconditioning, if appropriate, or puncture and dispose of in a sanitary landfill, or, by incineration, or by other procedures approved by state and local authorities.
Triple rinse containers small enough to shake (capacity < 5 gallons) as follows: Empty the remaining contents into application equipment or a mix tank and drain for 10 seconds after the flow begins to drip. Fill the container ¼ full with water and recap. Shake for 10 seconds. Pour rinsate into application equipment or a mix taink, or store rinsate for later use or disposal. Drain for 10 seconds after the flow begins to drip. Repeat this procedure two more times.