Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
- Product Families
Features & Benefits
- Labeling Claims
- Ready-to-Use Product Features
- Features
- For desired results use with ECO-888 Clear or ECO-788 Clay Wallcovering Adhesive
- Superior white hiding power
- Water-resistant for double cutting
- Promotes strippability
- LEED compliant
- NSF/ANSI 342 compliant
Applications & Uses
- Markets
- Applications
- Application Area
- Application
Recommended Uses: For use with all types and weights of wallcovering.
Compatible Coatings: For desired results, ECO-888 Clear or ECO-788 Clay Wallcovering Adhesive must be used.
Substrates: Apply over new, bare drywall,
Mildew-Resistant: All Roman products contain biocides for in-can preservation
- Specification Data
Coverage: Up to approx. 400-450 square feet per gallon
Drying Time:Typically dry-to-touch in approximately one hour and ready to hang wallcovering in three hours. Drying time will vary depending on the temperature, ventilation and humidity of the room.
- Application Instructions
Surface Preparation: Surface must be free from mold, mildew, grease and other residues, dry, smooth and structurally sound. Refer to the www.epa.gov website for removing mold and/or mildew. Before proceeding with any unusual conditions, consult your adhesive or wallcovering supplier.
Tinting: Can be tinted with universal tints; 4 oz. per 1 gallon maximum
Dilution: Do not dilute.
Application Method: Use only when the room temperature is above 50ºF. Apply at recommended spread rate using a brush, roller, or spraying system. Do not overspread.
Airless Spray:
PSI Capable: minimum 3000 PSI
Hose: 3/8” I.D. Tip Size: .015 and larger Gun PSI: 2000-2300 Clean-Up: Before the primer dries, remove the excess with clean water. Brushes and rollers should be cleaned immediately after use with warm, clean water.
Properties
- Color
- Physical Form
- Specifications
Value | Units | Test Method / Conditions | |
pH Level | 8.5 | - | - |
Viscosity | approx. 2,000 | cps | - |
VOC (Regulatory) | 0.0 | g/L | EPA Method 24 |
Regulatory & Compliance
- Certifications & Compliance
Safety & Health
- Warning
If you scrape, sand, or remove old paint, you may release lead dust. Lead is toxic. Exposure to lead dust can cause serious illness, such as brain damage, especially in children. Pregnant women should also avoid exposure. Wear a niosh-approved respirator to control lead exposure. Clean up carefully with a hepa vacuum and a wet mop.
- Caution
Do not take internally. In case of ingestion, seek medical attention. Avoid contact with skin and eyes. Use of skin and eye protection is recommended at all times. If contact with eye occurs, flush with water for 15 minutes. If skin contact occurs, wash with soap and water. Seek medical attention if rash or other symptoms occur. Do not mix with other chemicals. Use in a well-ventilated work area. Close container after each use. Keep out of reach of children.
Storage & Handling
- Storage
Avoid freezing. keep in cool, dry place.