Knowde Enhanced TDS
Identification & Functionality
- Product Type
- Technologies
- Product Families
Features & Benefits
- Ready-to-Use Product Features
- Product Advantages
- Bright white
- Elasticity
- Longevity
- Flexibility
- Ease of application
Applications & Uses
- Markets
- Application Area
- Product End Uses
- Recommended Uses
- It protects, beautifies, and insulates, displaying high reflective values for cooling your roof.
- Surfaces: Properly prepared steel, galvanized metal, aluminum, asphaltic aluminum coatings, and concrete roofs.
- Material Preparation
Mixing: Mix thoroughly by stirring with a lifting motion. Should be applied without thinning.
- Surface Preparation
- Surfaces to be coated must be clean, dry, and free of dirt, oil, or grease.
- Rust should be removed from metal surfaces by wire brushing, steel wool or industrial abrasive paper and apply one coat of Dyco #MP-50 White Metal Primer or comparable metal primer.
- On old surfaces, remove chalk by pressure cleaning or wire brushing; also, if necessary, seal the surface with a chalk sealer.
- If mildew is evident, use a mildew treatment.
- Repair all leaks with Dyco #20/20 Seam Seal brush on caulk or appropriate patching compound.
- If leaking areas are severe, embed fiberglass tape into the first layer of brush on caulk, and then apply another layer of brush on caulk over the taped area.
- Allow to dry thoroughly before applying Dyco #890.
- Application
Paintbrush, roller, or suitable spray equipment may apply.
- Recommended Coverage
- 10 mils wet
- 4 mils dry
- Avg. 150 sq. ft per gallon
- Reduction
Use ES110 Solvent Reducer
- Clean Up Solvent
Mineral Spirits
Properties
- Color
- Typical Properties
| Value | Units | Test Method / Conditions | |
| Sheen | Low Luster | — | — |
| Solids by Weight | 50.76 | % | — |
| Solids by Volume | 39.11 | % | — |
| Vehicle Solids by Weight | 18.14 | % | — |
| Pigment by Weight | 32.63 | % | — |
| Solvent by Weight | 49.24 | % | — |
| Viscosity | 108 - 112 | KU | Stormer |
| VOC | max. 550 | grams/liters | — |
| Weight Per Gallon | 9.07 | lbs | — |
| Flash Point | 105.0 | °F | — |
| Dry Time (70°F, 50%R.H., Touch) | 30.0 | minutes | — |
| Dry Time (70°F, 50%R.H., Recoat) | 45 - 60 | minutes | — |
Safety & Health
- Caution
- Combustible - contains petroleum distillates.
- Avoid contact with eyes and prolonged contact with skin.
- Use only in a well ventilated area.
- Do not use near heat, sparks, or flame.
- Do not apply below 32°F.