Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
Features & Benefits
- Ready-to-Use Product Features
Applications & Uses
- Markets
- Use
Installation
Approved Substrates: Interior floor surfaces such as plywood, underlayment grade hardboard, association grade particleboard, wood floors (sanded), resilient tile (non-cushioned and wax free), concrete (do not use on or below grade where excessive moisture, vapor, alkali or hydrostatic pressure exists). Carefully read and follow all instructions provided by the floor covering manufacturer. Before installation begins measure and mark the floor as necessary.
Please Note: Allow installation area, VCT and adhesive to acclimate to a temperature of 68°F for 24 hours before installation.
Preparation
Surface must be clean, dry, rigid, smooth, and free of all foreign matter. Remove loose tiles, dust, dirt, wax, paint, etc. Doubtful surfaces can be sanded and/or primed to enhance adhesion. Tongue-and-groove sub floors wider than 3" should be covered with underlayment sheeting. Patch all cracks, seams, or irregularities. Concrete must be fully cured, dry, and free of excessive moisture and alkalinity. If doubt exists about excessive moisture it may be checked by placing a rubber mat on the floor. Wait 24 hours, then lift mat and examine concrete underneath. If it is dry, proceed with floor covering installation.
Note: It is the responsibility of the User to properly prepare the surface or backing before the application of the adhesive. If doubt exists check with Seller or Manufacturer.- Application
Apply a smooth, uniform coating of adhesive to the floor. Allow adhesive to dry until tacky and transparent (approximately 30 minutes depending on temperature and humidity). Before applying tiles test for sufficient tack by gently running a finger over the adhesive. If adhesive does not transfer to finger, tiles may be applied. After tiles are placed in desired position, firmly press the surface with a linoleum roller or rolling pin to insure a firm bond and the expulsion of all air bubbles. Work from the center out, towards the edges, pushing in both directions. Tile may be installed up to 24 hours after adhesive has set.
Clean Up
Remove excess wet adhesive from tools, surface of tiles, etc. using water-dampened cloth or sponge. Dried adhesive may be removed using mineral spirits or other solvents. Exercise due care and follow all manufacturers' precautions when using solvents.
Properties
- Color
Technical Details & Test Data
- Curing
Curing
Protect installation from exposure to water, heavy traffic, and freezing temperatures for a minimum of 72 hours.
Safety & Health
- Safety
Warning! Eye And Skin Irritant.
Avoid contact with eyes, skin and clothing. Wash thoroughly after handling.
Keep Out Of The Reach Of Children!
Packaging & Availability
- Packaging Type
- Packaging
1 gallon and 4 gallon plastic pails. Color is off white and dries clear.
Coverage- Brush, 250-300 square feet per gallon.
- Roller, 200-250 square feet per gallon.
- Trowel,150-200 square feet per gallon. (using 1/16" x 1/16" x 1/16" square notch).
Storage & Handling
- Storage and Shelf Life
Store in original, tightly sealed container at room temperature. Protect From Freezing. Product is freeze-thaw stable, but freezing should be avoided whenever possible. Excessive cycling or prolonged frozen states can damage the adhesive. Shelf life is one year from date of manufacture.