Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
- Product Families
Features & Benefits
- Ready-to-Use Product Features
Applications & Uses
- Applications
- Application Method
- Uses
- Seaming
- Mitering
- Laminating
- Rodding
- Used With
- Natural & Engineered Stone
- Sintered Stone
- Ultra-Compact Stone
- Application
- All surfaces to be bonded must be clean and dry
- Load cartridge into dispensing gun, remove locking ring and cartridge plug. Prior to installation of the static tube mixer, the cartridge must be purged to ensure flow of both resin (Part A) and hardener (Part B) from the openings of the cartridge
- Install the static mixer onto the cartridge. The static mixer shall be filled by slowly and consistently squeezing the gun with the mixing tip pointed up (vertical) to remove all air. (Note: The locking ring that keeps the cartridge plug installed is also used to lock the static mixer onto the end of the cartridge)
- Once the static mixer is filled to the tip, material shall be purged into a cup or onto scrap cardboard (approximately 10g-20g) before applying to the material. (NOTE: When squeezing the trigger to push material through the static mixer, always squeeze at a constant/consistent rate and pressure. Faster and harder is not good as this causes varying back pressures and pulsing of the cartridge barrel which can lead to off-ratio and poor mix conditions)
- Apply adhesive to seam surface with 1-2 beads and set seam within 4-5 minutes
- Each cartridge color should be evaluated on surface materials that call out the specific cartridge colors as primary or alternate colors. Each cartridge color can be evaluated on other color surfaces of similar hues and shades as well
- Avoid bonding polished surfaces
- Remove / Save cap then install mixing tip provided
- After use, clean openings of both ports, replace cap and discard mixing tip
- Repeat this process for each use.
Properties
- Color
- Typical Properties
Value | Units | Test Method / Conditions | |
Consistency | Smooth Paste | — | — |
Mix Ratio | Premixed with mixing tip | — | — |
Gel Time | 5 - 7 | mins | — |
Cure Time | 20 - 25 | mins | — |
Packaging & Availability
- Packaging Type
- Packaging
- Quart
- Gallon
- 2-PAK
- 5-Gallon Pail
- Standard Big Box
- Enhanced Big Box
Storage & Handling
- Shelf Life
- 1 Year
- Vehichle Temperature
Outside Temp. Inside Temp. (10 Mins.) Inside Temp. (30 Mins.) 21°C 32°C 40°C 24°C 34°C 43°C 27°C 37°C 46°C 29°C 40°C 49°C 32°C 43°C 51°C 35°C 46°C 54°C - Storage
- Store indoors at room temperature
- Do not store above 75°F (24°C)
- High heat and cold temperatures will adversely affect the shelf life
- Avoid storage in direct sunlight and where freeze/thaw conditions may exist