company tower banner
SureCrete Company Logo
Super 20™ is a single-component, color-enhancing, high gloss sealer developed for concrete or any cement-based product. It is vapor permeable, yet reduces the penetration of fluids into the surface.

Product Type: 1K (1 component) Coating, Sealer

Application Area: Decking, Floor, Patios, Stucco

Compatible Substrates & Surfaces: Concrete

Features: Abrasion Resistant, Anti-Slip, Good UV Protection, High Gloss, Mechanical Stability, Stain Resistant, Vapor Permeable

Application Method: Spray

Chemical Family: Acrylics & Acrylates

  • TypeDocument Name
View All Documents

Knowde Enhanced TDS

Identification & Functionality

Chemical Family

Features & Benefits

Features

Super 20 will enhance the beauty, improve stain and abrasion resistance, and provide UV protection for driveways, garage floors, patios, brick pavers, walkways, pool decks, stucco, and concrete block.

Applications & Uses

Application Method
Compatible Substrates & Surfaces
Coverage

Varies upon substrate: approximately 180 - 200 ft² per gal., per coat 8 - 8.9 mils wet; 1.6 - 1.8 mils cured.

Suitability Sample
  • Due to condition-specific sites, always prepare an adequate number of test areas.
  • Wear protection system and esthetic suitability for products’ intended use should be included.
  • On site sample approval is especially critical on substantial, heavy traffic situation or custom coloration.
Clean Up

Before it dries; spills and tools can be cleaned up with a solvent such as xylene or acetone.

Limitations
  • Product performs best upon a concrete slab that has no ponding of standing water.
  • When masking use caution while taping to a floor that is not completely cured, especially at edges, as delamination may occur.
  • Protect from metal wheel traffic and some furniture where point of contact may be damaging.
  • Chemicals used in tire manufacturing may be detrimental to all sealers from vehicular parking.
Application Temperature

50°F - 90°F (10 - 32 °C)

Properties

Appearance
Clear (Wet), Clear High Gloss (Cured)
Odor
Solvent
Diluent
Hydrocarbons
Typical Properties
ValueUnitsTest Method / Conditions
Abrasion Resistance12.5g Loss
Adhesion (Dry Concrete)ExcellentASTM D-3359
Adhesion (Wet Concrete)ExcellentASTM D-3359
Block ResistanceExcellentASTM D-4946
Blush (4hr Dry/18hr Immersion)No Blush
Film Formation (40°F)Passed
Heat Stability (120°F)ExcellentASTM D-1849
Light StabilityExcellent
Mechanical StabilityExcellent
Pencil HardnessHB-HASTM D-3363
Solids20.0%
VOC Content600.0g/L
Water Absorption2.4g/m³
Water ResistanceExcellent, Beads Water

Regulatory & Compliance

Slip Resistance
  • Two recognized US agencies have issued directives on minimum coefficient of friction, OSHA (Occupational Safety and Health Administration) and Department of Justice through the ADA (Americans with Disabilities Act).
  • ADA is the more stringent of the two.
  • ADA directs that accessible walkways have a minimum coefficient of friction of 0.6.
  • Ramps have been directed to be 0.8. The applicator assumes the responsibility to meet these standards.
  • Areas that may become wet, oily, or greasy require special attention.

Technical Details & Test Data

Test Data

QUV Accelerated Weather Testing:

  • 250 hr. - no blistering, no yellowing (ASTM G-53)

Hot Tire Pick-up:

  • Passed
  • Under extreme circumstances delaminating could occur.
  • All tire manufacturers were not tested.
  • Chemicals used in tire manufacturing may be detrimental to all sealers from vehicular parking.
Chemical Resistance
Testing ASTM D-1308
Transmission fluid Resistant
Gasoline Remove immediately
Formula 409 Resistant
Motor oil Resistant
Brake fluid Remove immediately

Safety & Health

Cautions
  • Keep out of reach of children.
  • Product is flammable.
  • Avoid sources of ignition.
  • Keep areas ventilated to prevent the accumulation of vapors.

Inhalation:

  • Use NIOSH approved respirator for organic vapors.

Skin Contact:

  • Skin contact may cause irritation.
  • Remove contaminated clothing and wash affected skin with soap and water.
  • Launder clothing before reuse. If symptoms persist, seek medical attention.

Eyes:

  • Wear safety eye protection when applying.
  • If contact occurs, flush eyes with water for 15 minutes, seek medical attention.

Packaging & Availability

Packaging Type
Packing
  • 1 gal. (3.79 L) can
  • 5 gal. (18.9 L) pail
  • 55 gal. (208 L) drum

Storage & Handling

Shelf Life

Under normal, moisture free conditions 2 years for unopened container.