Knowde Enhanced TDS
Identification & Functionality
- Carrier
- Chemical Family
- Product Type
- Technologies
- Product Families
Features & Benefits
- Labeling Claims
- Ready-to-Use Product Features
- Product Features
Highly durable. The wood varnish is designed to protect wood surfaces and maintain the natural texture of the wood. Fast drying. Easy to apply. Free of lead and chromates. Certified eco-friendly.
Applications & Uses
- Applications
- Application Area
- Application Method
- Compatible Substrates & Surfaces
- Recommended Uses
Recommended for application on interior and exterior wooden surfaces, such as pergolas, garden furniture, roof frames, wooden fences, doors, door frames, children's furniture and toys.
- Technical Data
- Calculated coverage *: New, unpainted wood: 6-9 sqm./liter (in one coat)
- Painted wood: 13-16 sqm./liter (in one coat)
- Recommended dilution Water (see recommendation in “Application” section)
- Drying times: Touch **: 1 hour
- Recoat: 2-3 hours
- Final: 24 hours
* The actual coverage rate can vary, depending on the surface, the application mode, the painter’s skill and weather conditions at the site. Assume approximately 75% of the calculated coverage ability.
** At 25°C and 65% humidity.- Surface Preparation and the Painting System
- Do not apply on wet wood.
- New, Unpainted Wood and/or Painted Wood in Good Condition:
- Remove any dust, dirt and grease stains. Sand with sandpaper 0 or 360 and clean off sanding dust then apply Water Based Polyurethane Varnit.
Notice: To obtain high durability and maximum protection from UV radiation, apply the Water Based Polyurethane Varnit over Water Based tinted Varnit.
- Application
Stir the wood stain well before application and while painting. The wood stain appears to have a milky white color in its can and turns transparent once it is dry.
Soft brush application : Apply along the wood grain. Dilute the wood varnish with about 25% of water for the first coat to ensure good absorption in the wood. Apply the next coat without dilution. Apply several coats until a satin gloss is obtained. It is recommended to apply three coats. Between the coats, sand the surface lightly using sandpaper 0. The last coat should not be sanded.
Cleanup : Clean work tools with soap and water immediately after use. Close the container tightly to prevent air penetration.
Cautions : The paint is inedible; any work that includes application and use of this product shall be performed according to the applicable Safety, Health and Environmental regulations. Keep out of reach of children. Use in a well ventilated area only. Specific information regarding the product is available in the safety manual (MSDS). Avoid inhaling the paint or its vapors.
- General Notes
Do not apply when the wall is wet and/or rain is expected for about 72 hours before or after the application and/or the wall temperature is below 10°C and the relative humidity is above 85%. Do not mix this product with products not recommended by us. Achieving desired results is dependent on the proper application of the product while following all instructions. Before applying the product, the user must make sure that the product is indeed designed for the intended usage and that the surfaces to be painted are properly prepared, and are suitable for the product’s application. This product should be carefully tied down during transport.
Properties
- Color
- Appearance
- Satin gloss
Regulatory & Compliance
- Certifications & Compliance
Packaging & Availability
- Package Size
Package size Quantity per pallet
0.25 liter 1440 0.75 liter 576
Storage & Handling
- Shelf Life
- 24 Months
- Storage
Store in a roofed and well ventilated place.