Knowde Enhanced TDS
Identification & Functionality
- Product Type
- Technologies
- Product Families
Features & Benefits
- Ready-to-Use Product Features
- Advantages
- Water-clear formulation
- Excellent resistance to chipping/dings due to its
- elongation properties
- High gloss finish that is easy to maintain
- Easy 2 to 1 mix ratio
- 100% solids-no odor formulation
- Superior clarity
- Excellent wear durability
- Limitations
- Do not thin this product with any solvent
- Do not apply to a substrate below 55 Degrees F
- Limit exposure to harsh chemicals
Applications & Uses
- Markets
- Applications
- Product Application
Surface Preparation : New concrete must have a 28-day cure and be applied to a clean/sound substrate that is free of laitance and curing compounds. Mechanical preparation by means of shot-blasting or diamond grinding to a minimum of a CSP 2/3 as defined by ICRI, then properly vacuumed to remove any remaining dust.
Mixing : Pre-mix both components separately for approximately 1-2 minutes. Combine both components and mix an additional 3 minutes at a low to medium rpm. Applying Product: Pour product into “ribbons”, then spread with a high-quality squeegee. Backroll the material in the opposite direction of how it was squeegeed onto the surface. DO NOT TURN THE MIXING VESSEL (BUCKET) OVER ON THE FLOOR IN AN EFFORT TO UTILIZE THE ENTIRE CONTENTS.Typical Coverage will be between 80-160 square feet per gallon. This will vary depending on the surface to which the mixed product is applied.
Properties
- Color
- Physical Properties
| Value | Units | Test Method / Conditions | |
| Mix Ratio (Part A : Part B) | 1 : 1 | — | — |
| Solids Content | 100.0 | % | ASTM D-2697 |
| Viscosity (Mixed, 75°F) | 500 - 750 | cps | — |
| Abrasion Resistance (1000 cycles) | min. 50 | mg. loss | ASTM D1044 |
| Hardness | 75 - 79 | Shore D | ASTM D2240 |
| Application Temps | 55 - 80 | °F | — |
| Pot Life/Gel Time | 20 - 40 | minutes | — |
| Dry to Touch | 4 - 6 | hours | — |
| Foot Traffic | 8 - 10 | hours | — |
| Automotive Traffic | 24 | hours | — |
| Chemical Exposure | 7 | days | — |
Safety & Health
- Product Handling
Warning : For professional use only. Avoid contact of uncured material with skin and eyes. Contact with skin may result in irritation. Wash skin with soap and water. If contact with eyes should occur, flush with water for 15 minutes and seek immediate medical attention.
Packaging & Availability
- Packaging
Kit sizes are available are 1, 3, 15 gallons