Enhanced TDS
Knowde-enriched technical product data sheet
Identification & Functionality
- Product Type
- Technologies
- Product Families
Features & Benefits
- Ready-to-Use Product Features
- Features and Benefits
Features:
- Suction reduction
- Can be tinted
- Improves water resistance
Benefits:
- Increases workability of finish product
- Better final appearance after application of finish
- Reduces chances of efflorescence
Applications & Uses
- Markets
- Applications
- Uses
Ultraprime is an exterior acrylic primer designed for use over high pH surfaces such as stucco, prepared masonry or concrete and has excellent adhesion to primed metal and wood surfaces.
- Surface Preparation
Surface must be clean and free of bonding-inhibiting materials such as dirt, dust, rust, grease, oil, efflorescence, mildew, fungus, form-re- lease agents or any other contaminants. Remove and repair any loose paint, mortar, stucco, concrete or masonry by water blasting, sand blasting, scraping or using a wire brush. If applying over a painted surface, test paint to make sure it is load bearing.
- Coverage
Approximate coverage is 500 - 750 sq. ft. per pail at 4 mils. Dry thickness (coverage will vary depending on substrate, surface texture and application technique.)
- Clean Up
Clean tools immediately after use. Remove all debris from the surrounding areas immediately following the application process.
- Mixing
Mix with a drill mixer for 1 minute or until consistent prior to use. A pint (16 oz.) of potable water may be added to 5 gallons of Ultraprime for spray application.
- Application
Ultraprime exterior acrylic primer may be applied by roller, brush or spray equipment. Always apply Ultraprime in a continuous application, working to a wet edge to eliminate cold joints.
- Curing
Curing time averages 3 hours depending on ambient temperature, humidity and film thickness. Ultraprime will dry completely within 12 hours.
- Limitations
Ultraprime should be applied when surface and ambient conditions are between 45ºF and 100ºF and should be protected from rain for a minimum of 24 hours. Substrate must have a pH of 12 or lower.
Properties
- Typical Properties
| Value | Units | Test Method / Conditions | |
| Solids by Volume | 26 - 30 | % | - |
| Solids by Weight | 40 - 44 | % | |
| Viscosity | 115 - 125 | KU | - |
| VOC | 22.0 | g/L | - |
| Weight per Gallon | 10.3 - 10.7 | lbs | - |
Safety & Health
- Safety
Precaution: Keep out of the reach of children. Not for internal consumption. Do not apply in non-ventilated areas. Use protective equipment such as gloves, eye protection and clothing.
First Aid:
- In case of eye contact, flush with water at least 15 minutes.
- In case of skin contact, wash afected areas with soap and water. If irritation persists, Seek medical attention. Remove and wash contaminated clothing.
- If inhalation causes physical discomfort, remove to fresh air. If discomfort continues, any breathing dificulty occurs or if swallowed, Seek medical attention.
Disposal: Dispose of in accordance with local, state or federal regulations.
Warning: Keep out of the reach of children. Not for internal consumption, for industrial use only.
Spills: Scrape up and wash with water immediately. If material has set, scrape material with appropiate tools and clean with citric acid.
Prop 65: This product contains material listed by the state of California known to cause cancer, birth defects or other reproductive harm.
Packaging & Availability
- Packaging Type
- Packaging
5 gallon plastic pail 52 lbs. (23.5 kg)
Storage & Handling
- Shelf Life
- 1 year
- Storage
Store in cool dry place away from direct sunlight.