Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Agrochemical Functions
- Technologies
- Product Families
- Active Ingredient
S-metolachlor..........................................27.30%*
Glufosinate-ammonium...........................11.65%
OTHER INGREDIENTS..........................61.05%
TOTAL.................................................. 100.00%
*Contains 2.5 lbs active ingredient S-metolachlor, and 1.07 lbs active ingredient glufosinate per U.S. gallon.
Applications & Uses
- Markets
- Applications
- Application Technique
- Herbicide Target Species
- User Safety
User Safety Requirements
Follow manufacturer's instructions for cleaning/maintaining PPE. If no such instructions for washables exist, use detergent and hot water. Keep and wash PPE separately from other laundry.
USER SAFETY RECOMMENDATIONS
Users should:
Wash hands before eating, drinking, chewing gum, using tobacco, or using the toilet.
Remove clothing/PPE immediately if pesticide gets inside. Then wash thoroughly and put on clean clothing. Remove PPE immediately after handling this product. Wash the outside of
gloves before removing. Wash thoroughly and change into clean clothing as soon as possible.
- Directions For Use
It is a violation of Federal law to use this product in a manner inconsistent with its labeling.
Do not use this product until you have read the entire label. Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation.
- Mixing Instruction
INTERMOC alone: INTERMOC herbicide must be mixed with water to make a finished spray solution. Fill the spray tank 1/2 to 3/4 full with water, start agitation, add the appropriate amount of INTERMOC then add remaining water to fill tank. Agitate continuously while mixing and applying to maintain a uniform spray mixture.
Properties
- Physical Form
Regulatory & Compliance
- Certifications & Compliance
Safety & Health
- Precautionary Statements
HAZARDS TO HUMANS AND DOMESTIC ANIMALS
CAUTION. Harmful if swallowed or absorbed through skin. Causes moderate eye irritation. Avoid contact with skin, eyes, or clothing. Wash thoroughly with soap and water after handling and before eating, drinking, chewing gum, using tobacco or using the toilet. Remove and wash contaminated clothing before reuse.
Personal Protective Equipment (PPE)
Applicators and other handlers must wear:- Long-sleeved shirt and long pants
- Shoes plus socks
- Chemical-resistant gloves made of barrier laminate, butyl rubber >14 mils nitrile rubber > 14 mils, or Viton > 14 mils
- Environmental Hazards
Do not apply directly to water or to areas where surface water is present. Do not apply to intertidal areas below the mean high water mark. Do not contaminate water by cleaning of equipment or disposal of equipment wash waters or rinsate.
Glufosinate, an ingredient in INTERMOC herbicide, is toxic to vascular plants and must be used strictly in accordance with the drift and run-off precautions on this label in order to minimize off-site exposures.
Storage & Handling
- Storage And Disposal
Do not contaminate water, food, or feed by storage or disposal.
STORAGE: Do not use or store near heat or open flame. Keep the container tightly closed and dry in a well-ventilated place, not exceeding 1250 F. If storage temperature for bulk INTERMOC herbicide is below 320 F, do not pump the material until its temperature exceeds 320 F. Protect against direct sunlight.
PESTICIDE DISPOSAL: Wastes resulting from the use of this product may be disposed of on-site or at an approved waste disposal facility.
CONTAINER HANDLING:
[Rigid, Mon-refillable containers small enough to shake (i.e., with capacities equal to or less than 5 gallons)] Non-refillable container. Do not reuse or refill this container. Triple rinse container promptly after emptying. Triple rinse as follows: Empty the remaining contents into application equipment or a mix tank and drain tor 10 seconds atter the tlOW begins to drip. Fill the 1/4 tull With water and recap. Shake for 10 seconds. Pour rinsate into application equipment or a mix tank or store rinsate for later use or disposal. Drain for 10 seconds after the flow begins to drip. Repeat this procedure two more times. Once container is rinsed, then offer for recycling if available or reconditioning if appropriate; or puncture and dispose Of in a sanitary landfill, or by incineration; or, if allowed by State and local authorities, by burning. If burned, stay out Of smoke.
[Rigid, Mon-refillable containers (i.e., with capacities greater than 5 gallons)] triple rinse [or pressure rinse] as follows:
Triple rinse: Empty the remaining contents into application equipment or a mix tank. Fill the container 1/4 full with water. Replace and tighten closures. Tip container on its side and roll it back and forth, ensuring at least one complete revolution, for 30 seconds. Stand the container back on its end and tip it back and forth several times. Turn the container over onto its other end and tip it back and forth several times. Empty the rinsate into application equipment or a mix tank or store rinsate for later use and disposal. Repeat this procedure two more times. Then offer for recycling or reconditioning if available, or puncture and dispose of in a sanitary landfill, or by other procedures approved by state and local authorities. Do not cut or weld metal containers. Pressure rinse: Empty the remaining contents into application equipment or a mix tank and continue to drain for 10 seconds after the flow begins to drip. Hold container upside down over application equipment or mix tank or collect rinsate for later use or disposal. Insert pressure rinsing nozzle in the side of the container, and rinse at about 40 PSI for at least 30 seconds. Drain for 10 seconds after flow begins to drip. Then offer for recycling if available, or puncture and dispose
of in a sanitary landfill, or by incineration, or by other procedures allowed by state and local authorities.
[All refillable container types (containers with capacities greater than 50 lbs)]
Refillable container. Refill this container with pesticide only. Do not reuse this container for any other purpose. Cleaning before refilling is the responsibility of the refiller. This is a sealed returnable container to be used only for INTERMOC herbicide. When this container is empty, it must not be opened, cleaned, or discarded. Empty containers must be returned to the original purchase location.
[Bottom discharge Intermediate Bulk Container (IBC) (containers with capacities greater than 50 lbs)]
Refillable container. Refill this container with pesticide only. Do not reuse this container for any other purpose. Cleaning before refilling is the responsibility of the refiller. Pressure rinsing the container before final disposal is the responsibility of the person disposing of the container. Empty the remaining contents from the Intermediate Bulk container (IBC) into application equipment or mix tank. Raise the bottom of the IBC by 1.5 inch on the side which is opposite of the bottom discharge valve to promote more complete product removal. Completely remove the top lid of the IBC. Use water pressurized to at least 40 PSI to rinse all interior portions. Continuously pump or drain rinsate into application equipment or rinsate collection system while pressure rinsing. Continue pressure rinsing for 2 minutes or until rinsate becomes clear. Replace the lid and close bottom valve. Contact your Ag retailer for container return, disposal, and recycling directions.
SEED DISPOSAL: To dispose of out-of-date or otherwise unmarketable seed from plants, which have been treated with INTERMOC herbicide, broadcast and lightly incorporate seed into field soils using disk or other suitable implement. Any resulting crop may be destroyed by chemical or mechanical means. Alternatively, seed may be destroyed by deep burial, incineration or landfill disposal.