Knowde Enhanced TDS
Identification & Functionality
- FRAC Code
- Agrochemical Functions
- Technologies
- Active Ingredients
Tebuconazole: alpha-[2-(4-chlorophenyl)ethyl]-alpha-(1,1-dimethylethyl)-1H-1,2,4-triazole-1-ethanol 39% OTHER INGREDIENTS: 61.30% TOTAL: 100.00%
Applications & Uses
- Markets
- Applications
- Application Technique
- Fungicide Target Species
- User Safety Recommendations
Users should:
• Wash hands thoroughly with soap and water before eating, drinking, chewing gum, using tobacco, or using
the toilet.
• Remove clothing/PPE immediately if pesticide gets inside. Then wash thoroughly and put on clean clothing.
• Remove PPE immediately after handling this product. Wash the outside of gloves before removing. As
soon as possible, wash thoroughly and change into clean clothing.- Direction Of Use
It is a violation of Federal law to use this product in a manner inconsistent with its labeling. Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation.
AGRICULTURAL USE REQUIREMENTS
Use this product only in accordance with its labeling and with the Worker Protection Standard, 40 CFR Part
170. This Standard contains requirements for the protection of agricultural workers on farms, forests,
nurseries, and greenhouses, and handlers of agricultural pesticides. It contains requirements for training,
decontamination, notification, and emergency assistance. It also contains specific instructions and
exceptions pertaining to the statements on this label about personal protective equipment (PPE) and
restricted-entry interval. The requirements in this box only apply to uses of this product that are covered by
the Worker Protection Standard.
Do not enter or allow worker entry into treated areas during the restricted-entry interval (REI) of 12
hours for all crops.
PPE required for early entry to treated areas that is permitted under the Worker Protection Standard and
that involves contact with anything that has been treated such as plants, soil, or water is:
• Coveralls
• Chemical-resistant gloves such as barrier laminate, butyl rubber, nitrile rubber, neoprene rubber, polyvinyl
chloride, or Viton
• Shoes plus socks
NON-AGRICULTURAL USE REQUIREMENTS
The requirements in this box apply to uses of this product that are NOT within the scope of the Worker
Protection Standard for agricultural pesticides (40 CFR Part 170). The WPS applies when this product is
used to produce agricultural plants on farms, forests, nurseries, or greenhouses.
Entry Restrictions for Non-WPS Uses: Do not enter or allow others to enter the treated area until sprays
have dried.
Properties
- Physical Form
Regulatory & Compliance
- Chemical Inventories
Safety & Health
- Precautionary Statements
Harmful if swallowed or absorbed through skin. Causes moderate eye irritation. Avoid contact with skin, eyes,
and clothing. Wash thoroughly with soap and water after handling and before eating, drinking, chewing gum,
using tobacco, or using the toilet. Remove and wash contaminated clothing before reuse.PERSONAL PROTECTIVE EQUIPMENT (PPE)
Some materials that are chemical resistant to this product are listed below. If you want more options, follow the instructions for Category C on an EPA chemical resistance category selection chart.
Applicators and other handlers must wear:
• Long-sleeved shirt and long pants
• Chemical-resistant gloves such as barrier laminate, butyl rubber, nitrile rubber, neoprene rubber, polyvinyl chloride, or Viton
• Shoes plus socksFollow manufacturer’s instructions for cleaning/maintaining PPE. If no such instructions for washables exist,use detergent and hot water. Keep and wash PPE separately from other laundry.
ENGINEERING CONTROLS STATEMENTS
When handlers use closed systems, enclosed cabs, or aircraft in a manner that meets the requirements listed
in the Worker Protection Standard (WPS) for agricultural pesticides [40 CFR 170.240(d)(4-6)], the handler PPE
requirements may be reduced or modified as specified in the WPS.- Environmental Hazards
This pesticide is toxic to mammals, fish, and aquatic invertebrates. Do not apply directly to water, to areas where surface water is present, or to intertidal areas below the mean high water mark. Runoff may be hazardous to aquatic organisms in neighboring areas. Do not contaminate water when disposing of equipment washwater or rinsate. Ground Water Advisory: Tebuconazole is known to leach through soil into ground under certain conditions as a result of label use. Use of this chemical in areas where soils are permeable, particularly where the water table is shallow, may result in groundwater contamination. Surface Water Label Advisory: This product may contaminate water through drift of spray in wind. This product has a high potential for runoff for several months or more after application. Poorly draining soils and soils with shallow water tables are more prone to runoff that contains this product. A level, well-maintained vegetative buffer strip between areas to which this product is applied and surface water features such as ponds, streams, and springs will reduce the potential for contamination of water from rainfall runoff. Runoff of this product will be reduced by avoiding applications when rainfall is forecasted within 48 hours.
Packaging & Availability
- Packaging Type
Storage & Handling
- Storage And Disposal
Rigid, Nonrefillable containers that are too large to shake (i.e. with capacities greater than 5 gallons or 50 lbs). Nonrefillable container. Do not reuse or refill this container. Triple rinse or pressure rinse container (or equivalent) promptly after emptying. Triple rinse as follows: Empty the remaining contents into application equipment or a mix tank. Fill the container 1/4 full with water. Replace and tighten closures. Tip container on its side and roll it back and forth, ensuring at least one complete revolution, for 30 seconds. Stand the container on its end and tip it back and forth several times. Turn the container over onto its other end and tip it back and forth several times. Empty the rinsate into application equipment or a mix tank or store rinsate for later use or disposal. Repeat this procedure two more times. Offer for recycling or reconditioning if available, or puncture and dispose of in a sanitary landfill, or by other procedures approved by state and local authorities. Pressure rinse as follows: Empty the remaining contents into application equipment or a mix tank and continue to drain for 10 seconds after the flow begins to drip. Hold container upside down over application equipment or a mix tank or collect rinsate at about 40 PSI for at least 30 seconds. Drain for 10 seconds after the flow begins to drip. Once container is rinsed, offer for recycling if available, or puncture and dispose of in a sanitary landfill. Refillable Container. Refill this container with pesticide only. Do not reuse this container for any other purpose. Cleaning the container before final disposal is the responsibility of the person disposing of the container. Cleaning before refilling is the responsibility of the refiller. Refilling or Returning Containers. If refilling or returning container is planned, end users are not authorized to remove tamper evident cables, one way values or clean container. Recycle or Disposal of Containers. End users are authorized to remove tamper evident cable as required to remove the product from the container unless the container is equipped with one way valves and refilling or returning is planned. Instructions for container rinsing and either recycling or disposal are as follows: Bottom Discharge IBC (e.g. Schuetz Caged IBC or Snyder Square Stackable). Pressure rinsing the container before final disposal is the responsibility of the person disposing of the container. Cleaning before refilling is the responsibility of the refiller. To pressure rinse the container before final disposal, empty the remaining contents from the IBC into application equipment or mix tank. Raise the bottom of the IBC by 1.5 inches on the side which is opposite of the bottom discharge valve to promote more complete product removal. Completely pump or drain rinsate into application equipment or rinsate collection system while pressure rinsing. Continue pressure rinsing for 2 minutes or until rinsate becomes clear. Replace the lid and close bottom valve. Top Discharge IBC, Drums, Kegs (e.g. Snyder 120 Next Gen, Bonar B120, Drums and Kegs). Triple rinsing the container before final disposal is the responsibility of the person disposing of the container. Cleaning before refilling is the responsibility of the refiller. To triple rinse the container before final disposal, empty the remaining contents from this container into application equipment or mix tank. Fill the container about 10 percent full with water. Agitate vigorously or recirculate water with the pump for 2 minutes. Rinse all interior surfaces. Pour or pump rinsate into application equipment or rinsate collection system. Repeat this rinsing procedure two more times.