Knowde Enhanced TDS
Identification & Functionality
- Carrier
- Product Type
- Technologies
- Product Families
Features & Benefits
- Labeling Claims
- Ready-to-Use Product Features
Applications & Uses
- Application Method
- Compatible Substrates & Surfaces
- Application Instructions
Surface Preparation:
New Steel - Surface must be dry and free of contamination. Remove all weld spatter and grind all rough welds and edges to smooth contour. Previously Painted Surfaces - Must be free of oil, grease and other contamination. For best results, spot blast exposed areas to be primed. Power tool brushing may be used for minor touch up.
Spray:
Thoroughly mix coating prior to applying to substrate. Surface shall be dry, above 60° F and 5° above the dew point, and free of rust bloom. Double lap all welds, seams, corners, and edges to insure proper thickness. Make even parallel passes with 50% overlap to provide uniformity. This product has been formulated to be used at full strength. If reduction is required, water should be used.
Equipment:
HVLP, Air, Air Assisted Airless
Properties
- Color
- Physical Properties
| Value | Units | Test Method / Conditions | |
| VOC | max. 3.5 | lb/gal | - |
| Flash Point (TCC) | 130.0 | °C | - |
| Solids (by Weight) | 34.48 - 36.48 | % | - |
| Solids (by Volume) | 26.17 - 17.17 | % | - |
| Coverage (1 mils, 100.0% efficiency) | 428.0 | sq. ft./gallon | - |
| Dry (To Touch) | 30 - 45 | mins | - |
| Dry (To Handle, 75°F) | 2 - 4 | h | - |
| Hard Dry (75°F) | 24.0 | h | - |
| Sag | 5 - 6 | - | - |
| Closs (60°C) | 35 - 45 | - | - |
| Wet Film Thickness | 4 - 5 | mils | - |
| Dry Film Thickness | 1 - 3 | mils | - |
| Salt Fog (1000 Hours, Rating) | 9.0 | - | ASTM B-117/ D-1654 |
| Humidity | Pass | - | ASTM D-2247 |
| Impact | Good | - | - |
| Flexibility | Good | - | - |
| Hardness | HB-H | - | - |
| pH | 8 - 8.8 | - | - |
| Viscosity | 48 - 58 | " | #3 EZ Zahn |
| Weight | 9 - 9.3 | per gallon | - |
Safety & Health
- Safety and Handling
Use only with adequate ventilation and avoid breathing vapors. Wash hands thoroughly after handling. In case of eye contact, flush thoroughly with large amounts of water. Get medical attention if irritation persists. If swallowed, get medical attention immediately. For clean up, use water followed by dilute blend of water and butyl-cellosolve as soon as possible.