company tower banner
AgXplore International Company Logo
OnWard™ Max is a plant growth regulator for enhancing shoot and root growth, photosynthesis, abiotic stress resistance, and mineral uptake. OnWard MAX is specifically designed to enhance fruit/grain growth on the crops listed below. It supports the development of reproductive tissues, pollination of flowers and retention of seeds and fruits. The fortified) cytokinin in OnWard MAX allows better management of yield and quality for production of labeled crops. Always make a sample of OnWard" MAX and other products to determine tank mix compatibility prior to application. Mix the specified amount of OnWard" MAX in water to create a 0.5% solution and apply with sufficient volume for uniform and thorough coverage of foliage and/or fruit. Due to reduced coverage with gallonage of 5 gallons per acre or less, aerial application requires a minimum dose of 6.4 oz/acre (see footnote (3) below). Refer to the specific mixing rates in the table below.

Functions: Plant Growth Regulator (PGR)

  • TypeDocument Name
View All Documents

Knowde Enhanced TDS

Identification & Functionality

Agrochemical Functions
Technologies

Features & Benefits

Active Ingredients
ACTIVE INGREDIENTS By Weight
Cytokinin (as kinetin) 0.25%
Gamma Aminobutyric Acid (GABA) 2.00%
Choline Chloride 4.00%
OTHER INGREDIENTS 93.75%
TOTAL 100.00%

Applications & Uses

Directions For Use & Application Instructions

Directions For Use

It is a violation of Federal law to use this product in a manner inconsistent with its labeling. Do not apply this product in a way that will contact workers or other persons, either directhly or through drift. Only protected handlers may be in the area during applications.

Agricultural Use Requirements

  • Use this product only in accordance with its labeling and with the Worker Protection Standard, 40 CFR part 170. This standard contains requirements for the protection of agricultural workers on farms, forests, nurseries, and greenhouses, and handlers of agricultural pesticides. It contains requirements for training, decontamination, notification, and emergency assistance.
  • It also contains specific instructions and exceptions pertaining to the statements on this label about personal protective equipment (PPE), notification to workers, and restricted-entry interval. The requirements in this box apply to uses of this product that are covered by the Worker Protection Standard. Do not enter or allow worker entry into treated areas during the restricted entry interval (REI) of 4 hours. PPE required for early entry to treated areas (that is permitted under the Worker Protection Standard and that involves contact with anything that has been treated, such as plants, soil, or water), is: coverals, socks, shoes, chemical resistant gloves.

Application Instructions

OnWardM MAX is applied to foliage of ornamentals and leaves of bedding plants. Mixing instructions: dilute 6.4 fluid ounces of OnWardM MAX in 10 gallons (189.3 mL/10 gal) of water (1:200 dilution); for smaller quantities, mix 0.64 fluid ounces OnWardM MAX (1.3 Tbsp or 19.2 mL) per 1 gallon of water. Use sufficient volume of water to obtain uniform coverage. Thorough coverage is necessary for best results.

Regulatory & Compliance

Certifications & Compliance

Safety & Health

Precautions & Recommendations

Precautionary Statements

Hazards to humans and domestic animals

Caution

  • Causes moderate eye irritation. Avoid contact with eyes, skin or dothing.
  • Wash thoroughly with soap and water after handling and before eating, drinking, chewing gum, using tobacco or using toilet.

User Safety Recommendations

Users should wash hands before eating, drinking, chewing gum, using tobacco or using the toilet. Users should remove dothing/PPE immediately if pesticide gets inside. Then wash thoroughly and put on clean clothing. Users should remove PPE immediately after handling this product. Wash the outside of gloves before removing. As soon as possible, wash thoroughly and change into dean clothing.

Storage & Handling

Storage & Disposal

Do not contaminate water, food or feed by storage or disposal.

  • PESTICIDE STORAGE: Keep containers tightly closed when not in use.
  • PESTICIDE DISPOSAL: Wastes resulting from the use of this product may be disposed of on site or at an approved waste disposal facility.
  • CONTAINER HANDLING: Non-refillable container. Do not reuse or refill this container Triple Rinse as follows: Empty the remaining contents into application equipment or a mix tank and drain for 10 seconds after the flow begins to drip. Fill the container e full with water and recap. Shake for 10 seconds. Pour rinsate into application equipment or a mix tank or store rinsate for later use or disposal. Drain for 10 seconds after the flow begins to drip. Repeat this procedure two more times. Then offer for recycling if available or puncture and dispose of in a sanitary landfll, or by incineration, or, if allowed by State and local authorities, by burning. If burned, stay out of smoke.