Products

BorPak® is designed as a foliar spray for cotton, vegetables, and other crops. BORPAK can also be applied to soil where boron levels are low. This fertilizer is intended to be used as a supplement to a regular fertilization program based on soil tests and may not, by itself, provide all nutrients required by crops or other plants. Utilize a jar test if compatibility is questionable.

OnWard™ Max is a plant growth regulator for enhancing shoot and root growth, photosynthesis, abiotic stress resistance, and mineral uptake. OnWard MAX is specifically designed to enhance fruit/grain growth on the crops listed below. It supports the development of reproductive tissues, pollination of flowers and retention of seeds and fruits. The fortified) cytokinin in OnWard MAX allows better management of yield and quality for production of labeled crops. Always make a sample of OnWard" MAX and other products to determine tank mix compatibility prior to application. Mix the specified amount of OnWard" MAX in water to create a 0.5% solution and apply with sufficient volume for uniform and thorough coverage of foliage and/or fruit. Due to reduced coverage with gallonage of 5 gallons per acre or less, aerial application requires a minimum dose of 6.4 oz/acre (see footnote (3) below). Refer to the specific mixing rates in the table below.

Lignin Magnesium 5%™ is designed for use in all liquid fertilizers (exept aqua ammonia) and suspensions as a soil application for all crops requiring magnesium.

NitroUltra® is a unique blend of nitrogen, boron, and chelated copper, iron, manganese, magnesium and zinc. Specifically formulated for corn, soybeans, wheat and cotton, NITRO ULTRA can also be used on other crops where micronutrients would be beneficial. Utilize a jar test if compatibility is questionable.

Zinc 10%™ is designed for use in all liquid fertilizers (except aqua ammonial) and suspensions as a soil application. Utilize a jar test if compatibility is questionable.

OnWard™ is a plant growth regulator for enhancing shoot and root growth, photosynthesis, abiotic stress resistance, mineral uptake, and production of listed crops.

Zinc 20%™ Ammoniated is a liquid formulation of both primary (N) and micro (Zn) plant elements. It is formulated for use with pre-plant or liquid starter fertilizers, including polyphosphates, and nitrogen solutions. ZINC 20 is recommended for crops that require high zinc usage, such as corn, edible beans, onions, and potatoes.

Triple Zinc 12% is an essential nutrient needed for plant performance. Applied to corn, cotton, rice, soybean, wheat, other.

CalPak™ is designed to be sprayed on plant foliage. It will guard against calcium replacement in cell walls. A compatibility jar test is recommended before mixing and using full-scale. This fertilizer is intended to be used as a supplement to a regular fertilization program and may not, by itself, provide all nutrients required by crops or other plants.

Manganese 6% EDTA is a chelated micronutrient recommended for mixing with liquid fertilizers for use in pre-emergent application, application in irrigation water for use in either fertilizers and/or pesticides, and mixing with pesticide spray solutions in soil.

Zinc 9%™ is recommended to correct zinc deficiencies. Zinc 9% should be used on the basis of a soil and/or tissue analysis.

Charge™ is designed to be used primarily for foliar application. It may also be used with starter fertilizer or transplant water. CHARGE is intended to be a supplement to a regular fertilizer program. Rates on this label are for foliar application. May be applied by ground or air. Utilize a jar test if compatibility is questionable.