Knowde Enhanced TDS
Identification & Functionality
- Product Type
- Technologies
Features & Benefits
- Ready-to-Use Product Features
Applications & Uses
- Applications
- Application Method
- Compatible Substrates & Surfaces
- Typical Use
ACA 30-016 is designed, to bond and non-polar and polar surfaces such as polypropylene to aluminum and other metals. It will also bond metals to a variety of plastics and TPE/TPV, including Santoprene™. Since there are so many choices of metals and plastics in this class, testing is necessary to establish that a good bond is provided with a given application.
- Coating Method
The adhesive may be applied to metal foil by gravure printing, nip-fed reverse roll or wire wound bar coating methods. Brush, spray, or a paint roller may be used for unique shapes. The adhesive may be dried in a forced air oven at about 225°F. for a few seconds to yield an adhesive dry thickness between 0.3 and 0.75 mils. About 0.5 mils is a good place to start for adhesion evaluation. It may be necessary to run chill rolls on the oven output to avoid roll blocking and/or interleave a release liner.
Adhesive activation is accomplished at 400°F., 5 PSI, for 60 seconds. Conditions may differ depending upon the heat sealer and specific adherents.
ACA 30-016 is a dispersion and should be properly mixed prior to usage.
- Clean Up
Wash the equipment with water to remove the wet adhesive. The dry coating may require a toluene wash. Toluene is a flammable solvent and must be used according to OSHA safety standards.
Properties
- Typical Properties
Value | Units | Test Method / Conditions | |
VOC per Gallon | 0.02 - 0.04 | % | — |
Solids by Volume | 40 - 44 | % | — |
Solids by Weight | 44 - 48 | % | — |
VOC by Volume | 0.35 - 0.55 | % | — |
VOC by Weight | 0.3 - 0.5 | % | — |
Water by Volume | 57.0 | % | — |
Water by Weight | 53.0 | % | — |
pH | 7 - 8 | — | — |
VOC per Gallon Less Water | 0.07 - 0.09 | lb | — |
Viscosity | 100 - 300 | cps | — |
Weight per Gallon | 8.87 | lbs. | — |
Technical Details & Test Data
- Dry Adhesive Peel Values
Substrates AVG PEAK Santoprene™ 121-67 (pli) 22 27 Cast Vinyl (pli) 36 41 GM Test Bar (pli) 20 24 Polypropylene (pli) 24 30