Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Plastics & Elastomers Functions
- Technologies
- Product Families
- Composition
Proprietary synergistic blend of organic acids and esters with wetting agents, surfactants and emulsifiers in a water vehicle.
Features & Benefits
- Materials Features
Applications & Uses
- Markets
- Applications
- Recommended Uses
Unsaturated Polyester/Vinyl Ester-based SMC/BMC
- Application Method
Application Instructions: Spray
For best results we recommend spray applying the JB5. Spray JB5 with an HVLP spray gun and a pressure pot. Equipment: An 89 tip with a 95P fan for the HVLP gun attached to a pressure pot that has; air/water separator attached to an air regulator set to between 40-60 psi. Fluid pressure should be regulated to between 4 and 10 psi. Initial start-up settings at 5 psi fluid pressure and 50 psi air atomizing pressure recommended. The larger the mold cavity the higher the pressures can be set to help aid in delivery of the JB5. It is recommended that an up and down fan pattern be used (usually a one-half turn from the LEFT on most HVLP guns will produce an excellent fan pattern). For the fluid, only a one-half, to three-quarters turn from the RIGHT is all that is necessary. It is NOT recommended to open the fluid orifice more than one whole turn. Use water to flush the gun after use.
Application Instructions: By hand
Apply JB5 solution to clean tool by brush or clean cotton cloth applying in two directions. Proceed to mold on the wet release film. Test to determine how many multiple demoldings are possible before reapplying release agent.
Properties
- Typical Properties
| Value | Units | Test Method / Conditions | |
| Flash Point | Non-Flammable | °F/°C | - |
| pH | 7.5 – 8.5 | - | - |
| Solids | 3.2 – 3.8 | % | - |
| Specific Gravity (5°C) | 1.0 | - | - |
| Viscosity at 25°C | max. 15 | cPs | - |
Regulatory & Compliance
- Certifications & Compliance
Packaging & Availability
- Country Availability
- Regional Availability