Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
- Product Families
Features & Benefits
- Ready-to-Use Product Features
- Product Highlights
- Polyflon PTFE EK - 3700 grade is a water based PTFE topcoat.
- Polyflon PTFE EK - 3708S21R makes a gray topcoat layer displaying non stick property.
- It is good for cooking appliances and kitchen appliances.
Applications & Uses
- Markets
- Applications
- Application Area
Properties
- Physical Form
- Physical Properties
- Characteristics
- Physical Properties of Coated Film
- Note
1. The coating film was evaluated with a test piece below.
- Substrate: Aluminum plate roughened with Tosa Emely Extra #80/#100=50/50
- Primer: EK 1909S21R, approximately 10μm thick
- Topcoat: Approximately 20μm thick
2. Corrosion resistance test (Oden soup stock 5 cycles of the following; SB Oden soup stock is dissolved into 1L water and boiled for 1 hour Hot insulation for 7 hours Left unattended for 16 hours
3. The above values in properties are typical and not guaranteed.
| Value | Units | Test Method / Conditions | |
| pH | 9 | — | — |
| Solid Content | 40 | mass% | — |
| Specific Gravity of Coating | approx. 1.3 - 1.4 | — | — |
| Viscosity | 260 | cP | — |
| Value | Units | Test Method / Conditions | |
| Film Appearance | Gray | — | — |
| Value | Units | Test Method / Conditions | |
| Boiled Water Resistance (for 100 hours at 90~95°C) | Good | — | — |
| Corrosion Resistance | Good | — | Corrosion Resistance Test ² |
| Cross Cut Adhesion (Stripping with cellophane tape,10 times) | 100/100 | — | JIS K5400 8.5 |
| Gloss | 15 - 25 | — | JIS K5400 7.6 |
| Hot Oil Resistance (for 16 hours, at 260°C) | Good | — | — |
| Pencil Hardness (at 200°C, Stripping hardness of base material) | B - HB | — | JIS K6894 |
| Pencil Hardness (at 25°C, Stripping hardness of base material) | H - 2H | — | JIS K6894 |
| Salt Spray | Good | — | JIS Z2371 |
| Taber Abrasion (at 25°C, CS 17, 1kg, 1000 rounds) | 6 - 12 | mg/1000 rounds | — |
Safety & Health
- Handling Method / Safety Information
- Be sure to read the notes on SDS and labels before use.
- This product is intended for general industry, and therefore its adequacy and safety as a raw material for medical purposes cannot be guaranteed.