Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
- Product Families
- Composition
A mixture of organic polymers dissolved in an organic solvent system.
Features & Benefits
- Ready-to-Use Product Features
Applications & Uses
- Markets
- Application Method
- Compatible Substrates & Surfaces
- Surface Preparation
Roughen urethane or rubber surfaces with sand paper or a wire wheel. Wash with MEK or Trichloroethane prior to applying.
Application Temperature: 50 to 100 Deg F- Application
Slight agitation is required prior to use. May be applied to the cleaned substrate by brushing, dipping, spraying roller coating, or other method that gives a uniform coating and avoids excessive runs or streaks. Actual film should not exceed approximately 5 mils. After adhesive dries to a non-tacky film in a short amount of time, approximately 5 minutes at 77 Deg F, a second coat should be applied and allowed to dry to a slightly tacky surface, approximately 2 minutes. At this point the liquid or putty type urethane should be applied then allowed to complete the cure cycle for the particular product being used.
Properties
- Specifications
- Thinning Procedures
Thin with Methyl Ethyl Ketone
| Value | Units | Test Method / Conditions | |
| Viscosity (77°F) | 200 - 400 | cps | — |
| Volatile Content Weight | 60 - 70 | % | — |
| Coverage | 320.0 | sq. ft./gallon | — |
| Density | 6.8 - 7.0 | gallon | — |
| Flash Point (Pensky-Martens Closed Cup) | -25.0 | °F | — |
Safety & Health
- Caution
Flammable liquid, store away from all heat or open flames!!!
Storage & Handling
- Storage and Shelf Life
Do not store or use near heat or open flame
Shelf Life from date of shipment, unopened container, 70 - 80 Deg F: 6 Months
Storage: Systems should be stored unopened in air tight containers at 60 - 90 degrees F.- Handling
The bonding operation should take place as soon as the adhesive has tacked to avoid surface contamination.