Knowde Enhanced TDS
Features & Benefits
- Key Advantages
- Excellent chemical resistance
- Stain resistnat
- Seamless surface–does not promote microbial growth
- Optional: Polygiene® silver-ion antimicrobial agent
- Meets USGBC LEED criteria for IEQ 4.2 for low VOC
- Meets USDA requirements for incidental food contact
- High gloss finish
- System Options
- Optional urethane and epoxy topcoats depending onservice and chemical resistance required
- Polygiene® silver-ion antimicrobial agent
- Varied thickness per service requirements
Applications & Uses
- Typical Uses
- Laboratories
- Clean rooms
- Animal holding areas
- Commercial kitchens
- Food and beverage processing areas
- Pharmaceutical manufacturing areas
- Healthcare facilities
- Locker rooms and restrooms
- Numerous other uses–Consult with Key Resin
- Application
Surface Preparation
Surface Preparation is the most critical portion of any successful resinous wall system application. All substrates must be properly prepared and tested for moisture as outlined in Key Resin Technical Bulletin #1. Work must be performed by experienced contractors.
Installation
KEY THIN-FILM COATING SYSTEM material components are mixed on site.
Clean Up
Clean skin with soap and water. Tools and equipment should be cleaned with xylene or lacquer thinner.
- Maintenance
After completing the application of the KEY EPOXY/URETHANE WALL COATING SYSTEM, the installer should provide the owner with maintenance instructions. KEY EPOXY/URETHANE WALL COATING SYSTEMS are easily cleaned with neutral soaps or detergents.
Properties
- Physical Properties
- Fungus, Mildew, & Bacteria Growth
Will not support growth of fungus or bacteria when subjected to mildew and bacteria tests (MIL-F-52505§4.4.2.11).
Value | Units | Test Method / Conditions | |
Adhesion to Concrete (Concrete Failure) | 300 - 400 | psi | ASTM D7234 |
Hardness | 80 - 85 | Shore D | ASTM D2240 |
Flammability | Self Extinguishing over Concrete | - | ASTM D635 |
Abrasion Resistance | 30.0 | mg | ASTM D4060, CS17 Wheel, 1000 cycles |
Service Temperature (Dry Heat, Continuous) | 160.0 | ºF | - |
Service Temperature (Hot Water, Intermittent) | 200.0 | ºF | - |
Tensile Strength | 2400.0 | psi | ASTM D638 |
Packaging & Availability
- Availability
Key Resin wall systems are available throughout the United States and a number of other countries.