Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Polymer Name
- Composite Materials Functions
- Technologies
- Product Families
Features & Benefits
- Materials Features
Applications & Uses
- Markets
- Cure Method
- Plastics & Elastomers End Uses
- Processing instructions
When mixing a full pack, pour the hardener into the bigger bottle of resin. Put on the cap again and shake the bottle for some minutes. If smaller portions shall be used, it is necessary to use a scale for accurate weight of the components. Casting volumes exceeding 150 ml should cure at lowered temperature to avoid shrinking stress caused by high exothermic heat.
Cure the cast mixture for at least 24 hours at 23°C. Curing at elevated temperature, for ex. +40°C, will reduce the time to eight hours.
- Typical applications
- Incapsulation of electronic components.
- Impregnation of winded coils
Properties
- Chemical Resistance
- Color
- Typical Properties
Value | Units | Test Method / Conditions | |
Resin | NM El Epoxi 960 | - | - |
Hardener | NM Härdare 980 | - | - |
Mixing Ratio (Weight, Volume) | 70 - 30 (100 - 51) | - | - |
Hardness | 80 | - | - |
Density | 1088 | kg/m³ | - |
Viscosity | 250 | mPa·s | - |
Pot Life (100g 20°C) | 60 | minutes | - |
Compressive Strenght | 120 | MPa | - |
Tensile Strenght | 50 | MPa | - |
Coeficient Thermal Expansion | 60·10^{ - 6} | cm/cm·°C | - |
Volume Resistivity | 10^15 | Ohm-cm | - |
HDT | 50 | °C | - |
Cleaning Solvent | Acetone | - | - |
Dielectric (Constant 50 Hz) | 4 | - | - |
Packaging & Availability
- Normal Packing
0.525 + 0.225 = 0.750 kg
Storage & Handling
- Observe!
Do not leave any resin-mixture in the plastic bottle. The exothermic heat might melt the bottle.