Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Polymer Name
- CAS No.
- 68909-20-6
- Technologies
- Product Families
Features & Benefits
- Product Highlights
- Two-part, white silicone system used with
- injection molding equipmentCures with heat via addition-cure chemistry Designed to resist blocking on molded parts
- caused by radiation sterilization1:1 Mix Ratio (Part A: Part B)
Applications & Uses
- Applications
- Cure Method
- Plastics & Elastomers End Uses
- Plastics & Elastomers Processing Methods
- Applications
- For the injection molding of parts requiring a material with a medium durometer including: molded rubber stoppers, gaskets, seals, valves, o-rings and other precision partsSuitable for over-molding applications
- Can be used with NuSil’s Healthcare color masterbatches for applications requiring colored silicones
- Instructions for Use
Mixing
Combine Part A and Part B in a 1:1 mix ratio prior to use. Airless mixing, metering or dispensing equipment is recommended for production operations. If mixing by hand, take care to minimize air entrapment.
Vacuum Deaeration
Remove air entrapped during mixing by common vacuum deaeration procedure, observing all applicable safety precautions. Slowly apply full vacuum to a suitable container of at least four times the volume of material being de-aired. Hold vacuum until bulk deaeration is complete.
Substrate Considerations
Cures in contact with most materials common to biomedical assemblies, exceptions include: sulfur-cured organic rubbers, latex, chlorinated rubbers, some RTV silicones and unreacted residues of some curing agents.
Vulcanization
Curing of the blended elastomer is accelerated by heat. The pre-measured catalyst provides a fixed cure rate. Do not attempt to change molding times by mixing the two components in any other than a 1:1 ratio, as this will affect the properties of the elastomer. Only temperature adjustments should be employed to alter the rate of cure.
Properties
- Appearance
- White
- Typical Properties
- Cured Properties
Value | Units | Test Method / Conditions | |
Durometer Type A | 40.0 | — | — |
Tensile | 850 (5.86 ) | psi (MPa) | — |
Elongat ion | 350.0 | % | — |
Tear | 130 (22.93 ) | ppi (kN/m) | — |
Mix Rat io | 0.042361111 | — | — |
Specific Gravity | 1.17 | — | — |
Value | Units | Test Method / Conditions | |
Cure at 150 °C | 10.0 | minutes | — |
Cure System | Platinum | — | — |
Packaging & Availability
- Country Availability
- Regional Availability