Knowde Enhanced TDS
Identification & Functionality
- Technologies
- Product Families
Features & Benefits
- Ready-to-Use Product Features
- Features
- Protects concrete, epoxy, carpets, tile, and wood laminate
- Easy to use. No mixing required. Fast roll-on application
- Inexpensive. Typical investment under 35 cents per sq. ft
- Decreases flooring failures that need expensive repairs
- 4.5 pH improves bonding with epoxies and overlays
- One-part, water-based, zero VOC’s and odor free
- Seals concrete to reduce dusting and efflorescence
- Reduces damp odors caused by bacterial growth
- Dries and cures in less than one hour
Applications & Uses
- Applications
- Compatible Substrates & Surfaces
- Surface Preparation & Application Procedure
Surface must be completely clean and dry to the touch. Remove all dirt, wax, old paints or sealers with appropriate cleaners, chemical strippers, or abrasive blasting. For most dirt and lightly rusted or oily surfaces, we recommend using our PerfectCleaner®. SlabTight® is best applied using a roller in two thin coats. The second coat can be applied as soon as the first coat is dry to the touch. Back roll or back brush any pooling. Spray application with an HVLP sprayer or fine mist pump sprayer followed by with a 1/8” nap back roll is recommended. Brushing or using a 1/8” nap roller can be used but the sealer dries very quickly and the brush or roller would have to be rinsed every time there is a stoppage in application. Make sure that the application equipment is clean. Apply the sealer with a medium spray pattern. Because the sealer dries very quickly it is best to apply in several thin coats rather than one heavy one when a thicker film is needed. A visual color change indicates that the sealer is dry enough for an additional coat if needed. Clean application immediately with soap and water. Dried on product will require a strong solvent like acetone or MEK.
- Instruction Guide - Disclaimer
- Do not use on external masonry walls where a breathable coating is normally specified
- Do not apply this product when temperature is below 50°F
- Do not return unused material back into the original container
- Keep from freezing
- Do not dilute
Properties
- Typical Properties
| Value | Units | Test Method / Conditions | |
| Coverage (2 Coats) | 150 - 200 | Sq.ft/2 Gallon | - |
| Drying Time (Recoat) | 30.0 | min | - |
| Drying Time (Topcoat) | 60.0 | min | - |
Safety & Health
- First Aid
Inhalation: Remove person to fresh air. If breathing is difficult, administer oxygen. If breathing has stopped give artificial respiration and get medical attention.
Eyes: Rinse eyes with cool water for 15 minutes. Hold eyelids open during flushing with water. Get Medical Attention.
Skin Contact: Wash off with soap and water. Remove contaminated clothing. Ingestion: Harmful if swallowed. If ingestion occurs, do not induce vomiting. Seek immediate medical attention.
SlabTight ® is mildly acidic. Contact with the eyes may cause irritation and burning. Avoid prolonged contact with the skin. Applicators who are spraying large quantities should wear OSHA approved goggles and other appropriate safety equipment as per typical.
- Safety
All applicators must wear protective equipment customarily used when applying paints and coatings including gloves. Although SlabTight® is not caustic, avoid repeated or prolonged contact with the skin and eyes. Do not ingest or inhale the coating, modify the coating with any other material or use the coating for any nonrecommended purpose.