Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Polymer Name
- Reinforcement Material
- Composite Materials Functions
- Technologies
Features & Benefits
- Labeling Claims
- Materials Features
- Key Features
- Cure temperature from 65°C to 130°C
- Service temperature up to 160°C after post cure
- Work life at 20°C: 21 days
- Storage life at -18°C: 12 months
- Very low VOC content – no added solvents during manufacture
- Rapid lay-up – up to 50% faster than conventional systems
- High class finish with reduced pre-paint preparation
- Suitable for rapid prototype tooling applications
Applications & Uses
- Markets
- Applications
- Composites Processing Methods
- Typical Applications
Automotive Body Panels
Properties
- Typical Properties
| Value | Units | Test Method / Conditions | |
| Cure Temperature | 65 - 130 | °C | — |
| Outlife | 21 | — | months |
| Tg Onset | 170 | — | — |
| Tg Peak | 191 | — | — |
| Service Temperature | 160 | °C | — |
Technical Details & Test Data
- Cure Cycles and Performances
For optimum performance, it is recommended that the part is subject to a post cure of 180°C for 2 hours.
Cure Initial Min Cure Tg 65°C (minimun) 16 hours 70°C 75°C 8 hours 80°C 85°C 4 hours 90°C 100°C 2 hours 105°C 120°C 1 hours 125°C 130°C (maximum) 45 minutes 135°C 180°C Post Cure 2 hours 170°C Resulting panel thickness for APS75 surface and PSB75 bulking after full consolidation, around 1.5-1.7mm. For additional thickness and stiffness if required, additional PSB75 bulk or APS75 surface plies may be used.
Other cure cycles and additional reinforcements are available on request.- Curing Schedule is meant to be a guide only and is subject to local conditions.
- To avoid exotherm particular care must be taken with thick laminates.
Ramp rates must not exceed 3.0°C per minute during initial cure.
Ramp rates must not exceed 0.3°C per minute during post cure (free standing).
Volatile content < 1.0% Voidage (autoclave cure) < 1.0%
Safety & Health
- Health And Safety
This material contains epoxy resin which can cause allergic reactions with skin contact and must avoid repeated and prolonged skin contact.
The following precautions must be taken when using epoxy resin prepregs:
- Overalls must be worn.
- Impervious gloves must be worn.
- Curing schedule is meant to be as a guide only and is subject to local conditions.
- To avoid exotherm, particular care must be taken with thick laminates.
- Ramp rates must not exceed 3.0°C/min during initial cure and 0.3°C/min during post cure.
Packaging & Availability
- Packaging Type
Storage & Handling
- Storage and Out Life
This material should be kept frozen at -18°C. It must be kept sealed in a polythene bag which must not be opened until fully thawed to room temperature. If the material is not fully used, then the material must be resealed in the polythene bag to prevent moisture absorption.