Products

VTC401 is an epoxy resin system designed to give an initial cure at low temperatures or snap cure at high temperatures with enhanced toughness, honeycomb bondability and higher service temperature, giving greater flexibility in component manufacture. It can be supplied on a variety of fabrics in UD format to meet your cost and manufacturing requirements.

VTFA400 (DF034) toughened epoxy adhesive film is design to cure between 65°C and 120°C, allowing flexibility in component manufacture.

LTC216 Prepreg is designed to cure at low temperatures whilst giving the potential for high temperature tooling. Typical initial cure cycles are 40 hrs at 45°C or 16 hrs at 55°C, followed by a 200°C post cure. LTC216 can be supplied on a variety of fabrics to meet your cost and manufacturing requirements.

LTC102 Prepreg is designed to cure at low temperatures whilst giving the potential for high temperature tooling. It can be supplied on a variety of fabrics to meet your cost and manufacturing requirements.

OTS65 Tooling Prepreg has been formulated to give a robust surface finish with out of autoclave processing. It can be supplied on carbon or glass formats.

LTC150 Prepreg is designed to cure in a lower time at low temperatures than standard tooling prepregs whilst giving the potential for high temperature tooling. It can be supplied on a variety of fabrics to meet your cost and manufacturing requirements.