Enhanced TDS
Knowde-enriched technical product data sheet
Identification & Functionality
- Agrochemical Functions
- Technologies
- Product Families
Applications & Uses
- Markets
- Applications
- Applications
- TOXIMUL 8315 is 100% active nonionic surfactant used in emulsifiable concentrate and soluble liquid formulations and as a wetting agent in suspoemulsions and suspension concentrate formulations.
- Emulsifiable Concentrates
- Microemulsions
- Suspension Concentrates
- Suspoemulsions
Properties
- Formulation Type
- Physical Form
- Appearance
- Liquid
- Soluble in
- Water, Methanol, Xylene
- Insoluble in
- Kerosene
- Typical Properties
Value Units Test Method / Conditions Cloud Point (in 5% aqueous solution) 71 °C - Melt Range -34.86 to 40.43 ºC - Density (at 25°C) 1.05 g/ml - Melted Quantity (at 25ºC) 97.13 % - Flash Point min. 94 °C PMCC Flash Point Tester Hydrophobe Butanol - - Freeze Point -1 °C - Pour Point 3 ºC - Moisture Content 0.1 % - Base Butyl - - HLB 15 - - pH (in 1% aqueous) 6 - - Regulated Volatile Organic Chemicals 0 % U.S. EPA Average Molecular Weight 3500 - - Viscosity (at 25°C) 555 cPs - Surface Tension (0.1% Aqueous) 39.7 dynes/cm -
Regulatory & Compliance
- Certifications & Compliance
- Chemical Inventories
- Clearances
TOXIMUL 8315 is approved for use as an inert ingredient under U.S. EPA 40 CFR 180.960.
Technical Details & Test Data
- Melt Point Determination of TOXIMUL® 8315
- Rheology of TOXIMUL® 8315
Safety & Health
- Other Data DOT Classification
- Non-Hazardous
Packaging & Availability
Storage & Handling
- Storage & Handling
- Normal safety precautions (i.e. gloves and safety goggles) should be employed when handling TOXIMUL 8315. Contact with the eyes and prolonged contact with the skin should be avoided. Wash thoroughly after handling materials.
- Bulk Storage Information: Stainless steel and glass fiber-reinforced polyester tanks are recommended. Many oven-cured phenolic and epoxy/phenolic linings may also be used. Elevated storage temperature may be desirable to maintain ease of pumping. Temperatures up to 130°F (54°C) can be maintained for long periods of time without degradation of the product.
- TOXIMUL 8315 which has been stored in drums at temperatures below 55°F (13°C) may thicken or solidify. It may be fluidized by warming with a drum heater or in a steam room. Drums should be vented prior to heating to avoid excessive pressure build up. Product temperatures over 130°F (54°C) are not recommended.
- Workplace Exposure
Occupational exposure can occur primarily through skin contact or via inhalation of vapors and mists. Engineering controls, personal protective equipment, and other workplace practices should be used to control these exposures.