Knowde Enhanced TDS
Identification & Functionality
- Agrochemical Functions
- Technologies
Features & Benefits
- Biodegradability
The products are expected to be inherently biodegradable.
Applications & Uses
- Markets
- Applications
TOXIMUL 3404F series surfactants are general agricultural emulsifiers. They can be used alone or in combination with each other in an extensive range of pesticide formulations.
Properties
- Formulation Type
- Physical Form
- Appearance
- Dark amber liquid (at 25°C)
- Dispersible in
- Water, Kerosene
- Soluble in
- Methanol, Xylene
- Typical Properties
| Value | Units | Test Method / Conditions | |
| Density (at 25°C) | 1.03 | g/ml | — |
| Flash Point | 36 | °C | PMCC Flash Point Tester |
| HLB | 9 | — | — |
| Moisture Content | max. 1 | % | — |
| pH (5% in 1:1 IPA/H₂O) | 5.7 | — | — |
| Pour Point | max. -18 | °C | — |
| Regulated Volatile Organic Chemicals | 24 | % | U.S. EPA |
| Viscosity (at 25°C) | 930 | cPs | — |
Regulatory & Compliance
- Certifications & Compliance
- Chemical Inventories
- Clearances
- The components of TOXIMUL 3404F is listed in the following countries: U.S. (TSCA), Canada (DSL), Europe (EINECS and Polymer Exempt), Philippines (PICCS), New Zealand (NZIoC), Australia (AICS), and China (IECSC).
- TOXIMUL 3404F is approved for use as inert ingredients under U.S. EPA 40 CFR 180.910.
Safety & Health
- Health Effects
The products are expected to be slightly toxic orally (LD₅₀ >200 mg/kg) and may cause skin and eye irritation.
Packaging & Availability
- Packaging Type
- Standard Packaging
TOXIMUL 3404F is available in drums (450 lb, 205 kg) and in bulk quantities.
Storage & Handling
- Storage & Handling
- Normal safety precautions (i.e. gloves and safety goggles) should be employed when handling TOXIMUL 3400 series. Contact with the eyes and prolonged contact with the skin should be avoided. Wash thoroughly after handling material. Use in a well ventilated area away from sparks and open flame.
- Bulk Storage Information: TOXIMUL 3404F stored in drums at temperatures below 25°F (-4°C) may thicken or solidify. They may be fluidized by warming with a drum heater or in a steam room. Drums should be vented prior to heating to avoid excessive pressure build up. Product temperatures over 100°F (38°C) are not recommended as excessive solvent loss may occur. The flash point may be exceeded when warming to pump but the temperature should be below the flash point for storage.
- Workplace Exposure
Occupational exposure can occur primarily through skin contact or via inhalation of vapors and mists. Engineering controls, personal protective equipment, and other workplace practices should be used to control these exposures.