Products

Triangle Coatings Epoxy Acrylic DTM is a two-component water-based epoxy acrylic primer/finish that is intended for direct-to-metal applications over properly prepared surfaces. It dries to a tough finish that is extremely durable and performs well. Epoxy Acrylic DTM is a rust-inhibiting coating with a high build.

TriPrime™is a high-solids, solvent-reducible primer for iron and steel that dries quickly. It is intended for use in shop and CEM applications, as well as under all common finishes, including polyurethanes. TriPrime™ is intended for hand-cleaned iron and steel SSPC-SP1, SP2, or SP3, and provides active corrosion inhibition and undercutting protection. It is intended for HVLP and air assisted airless systems, but it can also be used with conventional or airless systems where legal. Most systems require thinning; see the instructions under "Recommended Thinning." Alkyd, silicone alkyd, and acrylic topcoats are all recommended.

Tripoxy™ is a two-component (1:1 mix ratio), high-solids, solvent-borne, polyamide cure, high-gloss epoxy enamel with USDA approval for incidental food contact. The cured film is extremely dense and hard, but not brittle. It is watertight and impermeable, making it suitable for submersion service. It is resistant to most common solvents, all alkalis, and most acids when splashed or spilled. The 41 series has good adhesion but only adequate wetting and penetration. Tripoxy, like all epoxies, chalks heavily when exposed to sunlight; this is noticeable after 6 months and continues for 12-18 months. Tritpoxey is also available in a clear form.