Knowde Enhanced TDS
Identification & Functionality
- Technologies
- Product Families
Features & Benefits
- Ready-to-Use Product Features
- Characteristics
ET1643 is an epoxy-based high thermally conductive structural bonding adhesive for electronic applications. It is a two-component, non-slump, addition-curing system that cures at room temperature or elevated temperature to provide strong bonding to metals such as aluminum, copper, and FR4 based printed circuit board with excellent thermal conductivity. The cured material also has very low CTE for better thermal cycle performances. ET1643 is both dispensable and printable.
- Special Features & Benefits
- High thermal conductivity & ambient curable
- High temperature stability
- Low CTE for stress compliance
- Low bleeding, low volatile
- Low ionic content
- Pre-added 7 mil glass bead for thickness control
Applications & Uses
- Applications
- Application Area
- Cure Method
- Typical Applications
- Aerospace electronics
- Automotive electronics
- Semiconductor and Telecommunications
- Between high heat power device and heat sink
- Thermally conductive structural bonding
- Thermally conductive vibration
- Processing Instruction
- Important! Only components A and B with the same lot number may be processed together! For the package in a container (not in a cartridge), to ensure homogeneity of the material, the components must be stirred thoroughly before they are removed or processed in order to uniformly disperse any fillers that might have settled during storage.
- We recommend running preliminary tests to optimize conditions for the particular application. Comprehensive processing instructions can be obtained by contacting directly to United Adhesives Inc.
Properties
- Typical Properties
- Typical Cured Properties
Value | Units | Test Method / Conditions | |
Density (As Mixed) | 2.8 | Gram /cc | ASTM D792 |
Mixing Ratio | 1:1 | By weight | - |
Viscosily As Mixed At 25°C | 180.0 | Pa.s | ASTM D2196 |
Value | Units | Test Method / Conditions | |
Adhesion (Avai Lap Shear) | min. 1800 | Psi | ASTM D1002 |
Coefficient Of Thermal Expansion (Greater Tha Tg) | 60.0 | ppm/°C | IPC-TM-650 |
Coefficient Of Thermal Expansion (Less Than Tg) | 18.0 | ppm/°C | IPC-TM-650 |
Cure Time (115°C) | 30.0 | Min | DSC |
Cure Time (25°C) | 18.0 | hr | DSC |
Cure Time (85°C) | 60.0 | Min | DSC |
Dielectric Strength | min. 500 | Volt/mil AC | ASTM D149 |
Heat Capacity (25°C) | 1.0 | J/gK | ASTM D1269 |
Pot Life (25°C) | 60.0 | Min | Viscosity double |
Temperature Usage | -80 to 200 | °C | TGA |
Glass Transmission | 75.0 | °C | DMA |
Thermal Conductivity | 2.0 | W/mK | ASTM D5470 |
Volume Resistivity | min. 10E+12 | Ohm-cm | ASTM D257 |
Young's Modulus | 6.7 | GPa | DMA |
Safety & Health
- Safety
General hygiene regulations should be observed.
Storage & Handling
- Storage
ET 1643 has a shelf life of at least 6 months when stored between 5°C and 30 °C in the originally sealed container. The 'Best use before end' date of each batch appears on the product label. Storage beyond the date specified on the label does not necessarily mean that the product is no longer usable. In this case however, the properties required for the intended use must be checked for quality assurance reasons.