Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Technologies
- Product Families
- Composition
Aqueous emulsion of proprietary resins and crosslinkers with various surfactants.
Features & Benefits
- Labeling Claims
- Materials Features
- Features
- Easy, spray or wipe on
- No HAPS
- No odor
Applications & Uses
- Applications
- Uses / Mold Preparation
Specifically designed for rubber, Thermoplastic and Thermoset Resins processed at temperatures up to 1000ºF
Mold Preparation In order for the release to work effectively, the mold must be thoroughly cleaned to remove previously used mold release and other surface contaminants which may be incompatible. New molds should be cleaned with solvent to remove protective lubricants and coatings. Molds coated with other semi-permanent release agents can be cleaned with CX-200HS of high pH detergent. Then, wipe down the mold with a mild cleaning solvent and thoroughly dry the surface.
- Application Instructions
Application Instructions The release performs best when sprayed on hot molds (preferably 80ºC/180ºF or higher). Apply using a clean, woven, lint free cloth, such as the Scott Shop Towels On A Roll ® , Kimberly-Clark WorkHorse ® rags or WypAll ® wipes, or even a good, heavy-duty plain white paper towel. Wet the cloth with release until it is damp but not dripping and wipe onto preferably warm mold surface using smooth even strokes until the film is uniformly dry without wiping marks. Mold release may also be sprayed on. Multiple coats (2-4) are necessary to achieve proper, uniform application of the release. Allow the coating to dry between applications. Cure the mold release by heating for 1 hour at 375ºF/190ºC. Best results are attained when the coating is cured for 1 hour at molding temperature. Touch-up coats, when applied, should be cured for about 5 minutes at elevated temperature prior to restarting production.
Removal Use CX-200HS to strip the release from the molds when desired.
Properties
- Typical Properties
Value | Units | Test Method / Conditions | |
Solids | 3 - 5 | % | — |
Specific Gravity (25°C) | 1 | — | — |
pH | 8.5 | — | — |
Flash Point | Non Flammable | — | — |
Viscosity (25ºC) | max. 15 | cps | — |
Regulatory & Compliance
- Certifications & Compliance
Packaging & Availability
- Country Availability
- Regional Availability
Storage & Handling
- Shelf Life
- 12 months in original unopened package
- Handling
Keep this water-based product from freezing and store
below 100ºF / 39ºC.
Mix well before using.