Products

CENTROMID 6.6 GF / PA 6.6 GF 30 is reinforced with 30% glass-fibers. This leads to stiffness and increased resistance in the binding substance and an increased heat distortion resistance at the same time. The impact strength is reduced, the tensile strength is increased up to 5.900 MPa. PA 6.6 GF 30-plastics are often used as housings or as spacer units.

CENTROLEN / PE-UHMW is polymerised with a modified Ziegler-Catalyst. The density is lowered and the sliding friction coefficient is improved. PE-UHMW distinguishes itself through its very high impact resistance and abrasion resistance. The BfR-/FDA approval assures physiological safety. Sliding guides or pump and wear parts are often manufactured from PE-UHMW.

CENTROMID 6 GF / PA 6 GF 30 is reinforced with 30% glass-fibers. This leads to stiffness and increased resistance in the composite material and an increased heat distortion resistance at the same time. The impact strength is reduced, the tensile strength is increased up to 8.700 MPa. PA 6 GF 30 plastics are often used as track and rope pulleys.

CENTROCAR CENTROCARB GF / PC GF 30 is reinforced with 30% short-glass-fibers. This leads to stiffness of the composite material and an increased heat distortion resistance at the same time. The effect of tension tears is reduced. The maximum short-term highest applicable temperature is increased to 140 °C. Due to the outstanding electrical properties, PC GF 30-plastics are often used as insulation parts in the electronics industry.