Products

CENTROCAR CENTROCARB GF / PC GF 30 is reinforced with 30% short-glass-fibers. This leads to stiffness of the composite material and an increased heat distortion resistance at the same time. The effect of tension tears is reduced. The maximum short-term highest applicable temperature is increased to 140 °C. Due to the outstanding electrical properties, PC GF 30-plastics are often used as insulation parts in the electronics industry.

CENTROMID 12 GF / PA 12 GF 30 is reinforced with 30% glassfibres. This leads to stiffness and increased resistance in the binding substance and an increased heat distortion resistance at the same time. The impact strength is reduced, the tensile strength is increased up to 6.000 MPa. PA 12 GF 30-plastics are often used as lever or valve components.

CENTROMID 6.6 GF / PA 6.6 GF 30 is reinforced with 30% glass-fibers. This leads to stiffness and increased resistance in the binding substance and an increased heat distortion resistance at the same time. The impact strength is reduced, the tensile strength is increased up to 5.900 MPa. PA 6.6 GF 30-plastics are often used as housings or as spacer units.

CENTROTRON GF 15 / PPS GF 15 is reinforced with 15% glass-fibers. This leads to stiffness and increased resistance of the binding substance and an increased heat distortion resistance at the same time. The tensile strength is increased to 5.000 MPa. Among other things, bearings, sensors or exhaust pipes are manufactured from PPS GF 15 plastics.

CENTROMID 6 GF / PA 6 GF 30 is reinforced with 30% glass-fibers. This leads to stiffness and increased resistance in the composite material and an increased heat distortion resistance at the same time. The impact strength is reduced, the tensile strength is increased up to 8.700 MPa. PA 6 GF 30 plastics are often used as track and rope pulleys.

CENTROTRON GF 40 / PPS GF 40 is strengthened with 40% glass-fibers. The result is additional stiffness and higher strength of the binding material and an increase of heat resistance stability at the same time. The bending strength increases to 14.000 MPa. PPS GF 40-plastics are often used in the automotive branch or in aircraft construction.

CENTROLEN / PP GF 30 is reinforced with 30% glass-fibers. This leads to stiffness and increased resistance in the binding substance and an increased heat distortion resistance at the same time. The impact strength is reduced, the tensile and bending strength is increased up to 6.500 MPa and/or 5.500 MPa. PP GF 30-plastics are often used as fan blades or air filter housings.