Knowde Enhanced TDS
Identification & Functionality
- Product Type
- Technologies
- Product Families
Features & Benefits
- Ready-to-Use Product Features
Applications & Uses
- Application Area
- Application Method
- Application Method
- Pad-print
Properties
- Typical Cured Properties
| Value | Units | Test Method / Conditions | |
| Viscosity | 10,000 - 12,000 | cps | — |
| Volume Resistivity | 1.1 x 10^14 | Ω - cm | — |
| Dielectric Strength | 1300 | volts/mil | — |
| Dissipation Factor (100 Hz) | 0.013 | — | — |
| Dielectric Constant (at 100 Hz) | 4.2 | — | — |
Regulatory & Compliance
- Certifications & Compliance
Safety & Health
- Safety & Handling
- Use with adequate ventilation.
- Keep away from sparks and open flames.
- Avoid prolonged contact with skin and breathing of vapors.
- Wash with soap and water to remove from skin.
- Keep containers closed to avoid contamination.
- If stored frozen allow containers to warm to room temperature, and thoroughly wipe off any condensation before opening.
Storage & Handling
- Shelf Life
- 6 months at 5°C, 12 months at -10°C, 3 months at 25°C
- Suggested Handling & Curing
Stir well before using. 118-02 is ready to use as supplied for spray and/or dip coating. Additional thinning may be accomplished by adding CMI #114-20(slow drying), or#113- 39(fast drying) thinner. Good properties for most applications result when cured of 5 minutes at 130°C. Good properties are also obtained on a variety of substrates by curing at temperatures ranging from 25°C to 175°C. NOTE: Add 1phr B-187 catalyst when using low temperature cures. The use of B-187 is suggested to impart a high degree of chemical resistance. End user is advised to experimentally determine temperature and time best suited for individual applications