Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
Features & Benefits
- Ready-to-Use Product Features
Applications & Uses
- Application Method
- Compatible Substrates & Surfaces
- Application Method
- Screen-print
Properties
- Physical Form
- Typical Properties
- Typical Cured Properties
- Consistency
Medium viscosity liquid
| Value | Units | Test Method / Conditions | |
| Minimum Cure Temperature | 50 | °C | — |
| Value | Units | Test Method / Conditions | |
| Volume Resistivity (X and Y Axis) | 1x10^12 | Ω - cm | — |
| Volume Resistivity (Z Axis) | 0.0001 | Ω - cm | — |
| Hydrolytic Stability | Excellent | — | — |
| Useful Temperature Range | -70 to 260 | ºC | — |
| Thermal Stability | Good to 325 | °C | — |
| Peel Strength | 9 - 11 | lbs./inch | — |
Regulatory & Compliance
- Certifications & Compliance
Safety & Health
- Safety & Handling
- Contains flammable solvents.
- Use with adequate ventilation.
- Keep away from sparks and open flames.
- Avoid prolonged contact with skin and breathing of vapors.
- Wash with soap and water to remove from skin.
Storage & Handling
- Shelf Life
- 2 months at 25°C, 6 months at 5°C, 12 months at -10°C
- Handling And Storage
122-44 is ready to use as supplied. Further thinning may be accomplished by adding small amounts of CMI 113-12 thinner. Apply thin film of adhesive to one or both surfaces to be bonded. Dry at room temperature for approximately 10 to 20 minutes. At this point, the surfaces should be pressed firmly together. Best properties, for most applications, result when cured for 5 to 10 minutes at 160°C. Good properties are obtained on a variety of substrates by curing at temperatures ranging from 55°C to 180°C. Alternately, the assembled part can be cured at room temperature, allowing 1 week to develop full strength. End user is advised to experimentally determine temperature and time best suited for individual applications. (See back of sheet for stepby-step directions.)