Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
- Product Families
Features & Benefits
- Ready-to-Use Product Features
Applications & Uses
- Applications
- Application Area
- Applying/Transfer Procedure
To ensure a good bond, the bonding surfaces should be free of any contaminants such as oils, greases, fingerprints, etc.
1. Remove the film from cold storage and allow it to warm to room temperature.
2. After the film has been warmed to room temperature, remove release liner from one side.
3. Preheat substrate to 50°C to 70°C.
4. Locate the adhesive onto the preheated substrate. Smooth out any trapped air by hand, with a roller or any other smoothing device. Some pressure is advisable to ensure intimate contact between the adhesive and substrate.
5. Allow the substrate to cool to room temperature (cooler is better) and remove release liner. This is very important to allow for easy and clean separation of the final release liner from the adhesive.
6. Place the two substrates to be bonded together under uniform pressure. It is advisable to preheat the devise(s) being used to apply pressure. An unheated device will result in longer cure times and less uniformity of cure.
7. Cure at the desired cure schedule. Refer to the cure schedules above for guide information.
Properties
- Typical Cured Properties
Value | Units | Test Method / Conditions | |
Volume Resistivity | 0.001 | Q-cm | — |
Thermal Conductivity | 6.5 | WimK | — |
Operating Temperature | -55 to 230 | °C | — |
Peak Temperature | 325 | °C | — |
Glass Transition Temperature (Tg) | 150 | °C | — |
Coefficient of Thermal Expansion below Tg | 50x 10^-6 | In/in/C | — |
Coefficient of Thermal Expansion above Tg | 60 x 10^-6 | In/in/C | — |
T-Shear Strength | min. 2000 | psi | — |
Peel Strength (Copper to copper at 90°) | 9 | Pli | — |
Regulatory & Compliance
- Certifications & Compliance
Technical Details & Test Data
- General Film Description
Substrate Type: PET Release Liner
Conductive Coating Type: Silver/PolymerProduct Code Adhesive Thickness (mils)
125-22-F1 1 125-22-F2 2 125-22-F3 3 125-22-F4 4 125-22-F5 5
Storage & Handling
- Shelf Life
1 month at 25°C or 3 months at -10°C.
- Handling and Storage
This product is shipped frozen and should be stored frozen to optimize shelf life. Care should be taken in handling frozen/cold sheets, they are more likely to crack at this point (avoid flexing film if stored at -40°C). Allow material to warm to room temperature before handling. Please refer to Applying/Transfer Procedure for more details.