Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Fillers Included
- Polymer Name
- Technologies
Applications & Uses
- Plastics & Elastomers Processing Methods
Properties
- Color
- Mechanical Properties
- Typical Properties
- Thermal Properties
- Electrical Properties
- Other Properties
- Processing Information
Processing Parameter Value Unit Cylinder/processing temperature 360 - 400 °C Mold temperature 140 - 160 °C Material temperature 3 - 4 °C - This material can be processed as a thermoplastic taking the normal technical provisions into account. The above mentioned information refers exclusively to the injection molding process.
- Processing should be carried out as gently as possible, in order to maintain the maximum fiber length in the component. Back pressure and injection rate should be adjusted to the component geometry accordingly. The optimum processing temperature depends upon the respective geometry of the molded part and can be different from machine to machine.
- Predrying
Predrying Value Unit Permissible residual moisture content < 0.02 % Drying temperature 140 - 160 °C Drying time 3 - 4 h - To achieve optimum mechanical properties, it is recommended to pre-dry the material w ith the above mentioned parameters.
Value | Units | Test Method / Conditions | |
Charpy Impact Strength | 40 | kJ/m2 | DIN EN ISO 179-1eU |
Elongation at Break (50 mm/min) | 1.5 | % | DIN EN ISO 527-1 |
Modulus of Elasticity (Tensile test, 50 mm/min) | 17300 | MPa | DIN EN ISO 527-1 |
Tensile Strength (50 mm/min) | 220 | MPa | DIN EN ISO 527-1 |
Value | Units | Test Method / Conditions | |
Density | 1.35 | g/cm3 | - |
Value | Units | Test Method / Conditions | |
Glass Transition Temperature | 143 | °C | DIN 53765 |
Melting Temperature | 343 | °C | DIN 53765 |
Service Temperature (long term) | 260 | °C | - |
Service Temperature (short term) | 300 | °C | - |
Value | Units | Test Method / Conditions | |
Surface Resistivity | 5.83 x 10^2 | Ω*m | DIN EN ISO 3915 |
Value | Units | Test Method / Conditions | |
Bulk Density | 0.64 | g/cm3 | EN ISO 60 |
Storage & Handling
- Storage & Shelf Life
- The granules must be stored in dry, normally tempered rooms and in closed containers. For moisture-sensitive materials, the granules must be sealed airtight. Protection against direct sunlight must be guaranteed. The granules are usually subject to the requirements of no shelf life limitation. Shelf Life maybe limited by some additives.