Terratek® SC SC65

Identification & Functionality

Polymer Name

TPS/PP Alloy

Plastics & Elastomers Functions

Resin

Technologies

Plastics

Product Families

Plastics — Engineering & Specialty Polymers

Biodegradable Polymers,

Blends & Alloys

Features & Benefits

Labeling Claims

Bio-based,

Biodegradable,

Environmentally Friendly,

From Renewable Resources,

Sustainable

Materials Features

Biodegradable,

High Stiffness,

Low Mold Shrinkage,

Renewable Resource Content

Applications & Uses

Markets

Consumer Goods

Applications

Consumer Goods — Housewares

Consumer Goods — Sports & Recreation

Plastics & Elastomers End Uses

Credit/Smart Cards,

Film,

Housewares,

Profiles,

Sporting Goods,

Toys

Plastics & Elastomers Processing Methods

Extrusion,

Injection Molding,

Profile Extrusion

General Processing Recommendations

Due to the hydroscopic nature of the natural fillers in this material, pre-drying the resin may be required. Green Dot recommends that the moisture level of the resin not be above 0.3% as measured by loss-in-weight at 300°F for 15 minutes. If the moisture is above the recommended level, the resin should be dried in a desiccant dryer at 150°F until the moisture is at or below the recommended level. Failure to dry the material can cause processing problems normally associated with moisture in plastics.

For best molding results, larger gates and runners are recommended. The injection pressure required to fill the mold is much higher than typical injection molding grade plastics.   Typical injection molding temperatures are listed below, these are a guide and may need to be changed based on the particular application :

Rear	350°F to 360°F
Middle	350°F to 360°F
Front	360°F to 375°F
Nozzle	360°F to 375°F
Mold	60°F to 170°F

The melt temperature of the resin should remain below 400°F to prevent the material from discoloring and having a burnt odor.  

Properties

Typical Properties

	Value	Units	Test Method / Conditions
Specific Gravity	1.2	—	ASTM D792
Shrinkage	0.011	in/in	—
Melt Index (230°C, 2.16kg)	10	g/10 min	ASTM D1238
Tensile Strength	3770	psi	ASTM D638
Tensile Modulus	375826	psi	ASTM D638
Flex Strength	7893	psi	ASTM D790
Flex Modulus	400000	psi	ASTM D790
Elongation	2.17	%	—
Notched Izod	0.3	ft lb/in	ASTM D256

Regulatory & Compliance

Certifications & Compliance

USDA BioPreferred

Packaging & Availability

Packaging Type

Gaylord Boxes

Packaging

Terratek® SC65 resin is typically packaged in a sealed plastic-lined Gaylord at 1200 lbs/Gaylord.

Storage & Handling

Storing

The product should be stored in a cool, dry, and sanitary area to achieve maximum stability.