Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Technologies
- Product Families
- Category
Epoxy Floor Coatings and Primers, Epoxy Primers
Features & Benefits
- Ready-to-Use Product Features
- Product Features
- Excellent penetration and high “wetting out” properties.
- Excellent adhesion to concrete and masonry surfaces.
- Good water, salt and chemical resistance.
- Prevents “dusting” by increasing strength of concrete surfaces.
- Excellent abrasion resistance over concrete.
- Designed as a primer for high performance epoxies and polyurethanes.
- Protects bond line deterioration.
- Excellent against staining.
- USDA approved.
Applications & Uses
- Markets
- Applications
- Application Area
- Compatible Substrates & Surfaces
- Product Uses
Recommended as a deep penetrating sealer to protect new and old concrete surfaces from attack by chemicals, water and effects of freeze/thaw cycles. The resulting tight film helps prevent “dusting” of the concrete, spalling, and deterioration. Excellent sealer for warehouse floors, aisle-ways, parking decks, concrete slabs and walls, bridges, loading docks, exterior walks, runways, dams, driveways, garages, shop floors, and secondary containment areas. PC-149 can be made into a non-skid finish. Used as a primer for Gulf Coast Paint’s PC-200, CM-15, PC-636, PC-500, PC-517, PC-555, Epoxies, CT-352 and CT-370 Polyurethanes.
- Application
Spray, brush or roller
- Pot Life
8-10 hrs. @ 75°F
- Recoat Time
@ 75°F at 3.0 dry mils. Minimum Recoat: 8 hours, or overnight. Maximum Recoat: 48 hours
- Mixing Ratio
1:1 by volume. Mix 1 part Base (Part A) to 1 part Hardener (Part B)
Properties
- Color
- Typical Properties
| Value | Units | Test Method / Conditions | |
| Gloss | High Gloss | — | — |
| Volume Solids | 51.36 - 58.64 | % | — |
| V.O.C. | 3.23(387) | lbs./gal.(GMS/L) | — |
| Coverage (Theoretical, 1.0 mil DFT) | 882.0 | sq. ft. per gallon | — |
| Recommended Coverage | 176-294 sq. ft. per gal to yield 3-5 mils DFT (coverage will vary with porosity of concrete) | — | — |
| Induction Time | 30.0 | minutes | — |
| Application Temperature | 50 - 120 | °F | — |
| Dry Service Temperature | max.150 | °F | — |
| Thinning | Normally none required, can use up to 10% with SA-65 | — | — |
| Clean Up | SA-17 or S-74 | — | — |
Regulatory & Compliance
- Certifications & Compliance
Packaging & Availability
- Packaging
10 gal. unit, 2 gal. unit
Storage & Handling
- Shelf Life
1 Year Minimum