Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- CASE Ingredients Functions
- Technologies
- Product Families
Applications & Uses
- Applications
- Compatible Polymers & Resins
- Compatible Substrates & Surfaces
- Applications
RELEASE ST1 is a compound in solvent solution, designed to replace the normal Release coat (Release PP 25S or RELEASE K100D) in the production of PP adhesive packaging tapes, in order to achieve tapes which will be printable with a single-step printing machine (similar to PVC tapes, without using primer and release) using only suitable inks (see notes below).
Properties
- Typical Properties
Value | Units | Test Method / Conditions | |
Total Solids | 13±1 | % | — |
Brookfield Viscosity 25°C | 501.0 | mPa.s | — |
Solvents | toluene, isopropyl alcohol, xylene | — | — |
Packaging & Availability
- Packaging Type
- Packaging and Storing
Packaging
The product is supplied in iron drums (50 kg).
Storing
RELEASE ST1 gels at low temperatures and must be kept at 20°C or above. In case of freezing, good heating and stirring will be necessary. The product must also be stirred every time before removing partial quantities from containers. Use within 12 months from production date (unopened and in the original packaging).
Storage & Handling
- Shelf Life
- 12 Months
- Handling
RELEASE ST1 must be heated and well stirred before use, until it becomes perfectly fluid.
Product temperature should never go below 20°C (preferably between 30-40°C).
Suggested dilution: 0.8% of total solids content. Add 1 p/w (part by weight) of RELEASE ST1 with 15 p/w of a blend of toluene and isopropyl alcohol (70 : 30).
Suggested coating weight: 4-6 g (wet)/sqm on flame treated BOPP film (38-42 dynes/cm).
That means 0.04 g (dry)/sqm. Coating must be perfectly dried (less than 0.6% of residual solvents).
Hot-melt or solvent rubber adhesives can be coated directly on line on the other treated side of the BOPP film.