Knowde Enhanced TDS
Identification & Functionality
- Plastics & Elastomers Functions
- Technologies
- Product Families
Features & Benefits
Applications & Uses
- Markets
- Plastics & Elastomers End Uses
- Plastics & Elastomers Processing Methods
Properties
- Typical Properties
- Note
- ¹ Measured with Melt Indexer
- ² Measured with DSC, both heating and cooling speeds of 10°C /min
- ³ Measured at 23°C / 65%RH
- ⁴ Measured with Micromeritics Gas Pycnometer at 23°C
- * The above figures are representative values and are not guaranteed.
Value | Units | Test Method / Conditions | |
Melt Flow Rate (at 210°C, 2160g)¹ | 30 | g/10min | — |
Melting Point ² | 187 | °C | — |
Volatile Matter (120°C, 3hr) | max. 0.5 | wt% | — |
Glass Transition Temperature (Tg) ² | 74 | °C | — |
Crystallization Temperature ² | 141 | °C | — |
Oxygen Transmission Rate ³ | 0.4 | cc 30μm/m² day atm | — |
Density⁴ | 1.30 | g/cm³ | — |
Regulatory & Compliance
- Certifications & Compliance
Technical Details & Test Data
- Compostability and Biodegradability
OKS-8077P(AVE8077P) is certified with the following regulation.
- Example of Processing
Recommendable Screw Design:
(a) L/D of Extruder: 24 - 30
(b) Screw Design: Full - flight type is recommendableUnnecessary mixing may generate gels
Too long feed-section cannot discharge the gas to air
(c) Compression Ratio: 3.0 - 3.5
- Too small C.R. causes insufficient melting.
- Too large C.R. causes excessive heat-generated.
(d) Plating
- Chrome Plating ; Easy and Reasonable
- Nickel Alloy Plating ; Flat Surface, but High Cost
Processing Temperature:
Storage & Handling
- Storage Information
Please kindly do not leave the bag of AVE8077P open for a long time. When storing after open, please seal the bag as soon as possible in order not to absorb moisture. High moisture content of AVE8077P may cause bubbling trouble during extrusion processes.
- Safety Measures
- AVE8077P is intended for indirect food contact only. Quality assurance and hygiene for cosmetics and pharmaceutical applications are not considered.
- AVE8077P would be ignited by heat storage if AVE8077P is kept high temperature for a long time. When storing or disposing of the molded AVE8077P, please kindly cool it to 50 degree C or less.