Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
Features & Benefits
- Ready-to-Use Product Features
- Product Highlights
- Pourable, optically clear, two-part silicone elastomer
- Cures with heat via addition-cure chemistry
- 1:1 Mix Ratio (Part A: Part B)
Applications & Uses
- Applications
- Application Area
- Cure Method
- Plastics & Elastomers End Uses
- Applications
- For use in potting, encapsulating, coating, and injection or transfer molding applications
- Instructions for Use
Mixing
Combine Part A and Part B in a 1:1 mix ratio prior to use. Airless mixing, metering or dispensing equipment is recommended for production operations. If mixing by hand, take care to minimize air entrapment.
Vacuum Deaeration
Remove air entrapped during mixing by common vacuum deaeration procedure, observing all applicable safety precautions. Slowly apply full vacuum to a suitable container of at least four times the volume of material being de-aired. Hold vacuum until bulk deaeration is complete.
Cure Inhibition
Curing may be inhibited by traces of amines, sulfur, nitrogen oxide, organotin compounds, and carbon monoxide. Because organic rubbers often contain these substances, they should not come in contact with the uncured elastomer. Catalyst residues from silicone RTV elastomers and peroxide-cured silicone elastomers may also inhibit the cure.
Properties
- Typical Properties
- Cured Properties
| Value | Units | Test Method / Conditions | |
| Durometer Type A | 50.0 | — | — |
| Viscosity | 73,500 (73,500 ) | cP (Mpa*s) | — |
| Work Time | 52.0 | hours | — |
| Tensile | 740 (5.1 ) | psi (MPa) | — |
| Elongat ion | 380.0 | % | — |
| Mix Rat io | 0.042361111 | — | — |
| Refractive Index | 1.41 | — | — |
| Specific Gravity | 1.04 | — | — |
| Tear | 80 (14.11 ) | ppi (kN/m) | — |
| Value | Units | Test Method / Conditions | |
| Cure at 150 °C | 30.0 | minutes | — |
| Cure System | Platinum | — | — |
Packaging & Availability
- Country Availability
- Regional Availability