Knowde Enhanced TDS
Identification & Functionality
- Agrochemical Functions
- Technologies
Applications & Uses
- Markets
- Applications
- STEPFACTSP-PE N can be used as an anionic emulsifier or dispersant in a variety of agricultural applications, including suspension concentrates and other liquid formulation types.
- SC, adjuvants, EW, EC, ME, OD, RTU, SE, WG and WP
Properties
- Formulation Type
- Physical Form
- Appearance
- Hazy, yellow liquid (at 25°C)
- Soluble in
- Water, Methanol, Xylene
- Dispersible in
- Kerosene
- Typical Properties
Value | Units | Test Method / Conditions | |
Actives Content | 97.5 | % | — |
Average Moles of Ethylene Oxide | 16 | — | — |
Color | 3 | — | Gardener Scale |
Density (at 25°C) | 1.15 | g/ml | — |
Flash Point | min. 94 | °C | PMCC Flash Point Tester |
Moisture Content | 2 | % | — |
pH (in 5% aqueous) | 7.5 | — | — |
Pour Point | 5 | °C | — |
Viscosity (at 25°C) | 4000 | cPs | — |
Regulatory & Compliance
- Certifications & Compliance
- Chemical Inventories
- Clearances
- STEPFAC TSP-PE N is regulated under TSCA Section 5(a) – “Significant New Use Rules” and 12(b) – “Export Notification”.
- All components of STEPFAC TSP-PE N are listed in the following countries; the registration number for the active ingredient is included in parentheses: United States (TSCA 105362-40-1), Australia (105362-40-1), Philippines (PICCS 105362-40-1), Korea (ECL Serial No. KE-25947), China (IECSC 105362-40-1), Europe (Polymer Exempt), and New Zealand (NZIoC 105362-40-1).
- Approved for non-food use only.
- It is the responsibility of the formulator to review the chemical control regulations for each country where the end product is intended to be sold or used.
Safety & Health
- Toxicity
STEPFACTSP-PE N is slightly toxic orally in rats (LD₅₀> 4750 mg/kg). The product may cause mild skin and eye irritation.
- Other Data DOT Classification
- Non-Regulated
Packaging & Availability
- Standard Packaging
Available in drums (450 lb, 200 kg) or bulk.
Storage & Handling
- Storage & Handling
- Safety precautions (gloves and safety goggles-face shield, if splashing may occur) should be employed when handling STEPFAC TSP-PE N. Avoid contact with eyes and skin should. Wash thoroughly after handling materials.
- Bulk Storage Information: Elevated temperature may be desirable to maintain ease of pumping, but product should be stored long term at ambient temperature.
- STEPFAC TSP-PE N that has been stored in drums at temperatures below 50 °F (10 °C) may thicken or solidify. Product may be fluidized by warming with a drum heater or in a steam room. Drums should be vented prior to heating to avoid excessive pressure build up. Product temperatures over 130 °F (54 °C) are not recommended.