Knowde Enhanced TDS
Identification & Functionality
- Agrochemical Functions
- Technologies
Applications & Uses
- Markets
- Applications
TOXIMUL 3470F series surfactants are general agricultural emulsifiers. They are used in combination with each other, generally in pairs, in an extensive range of pesticide formulations.
Properties
- Formulation Type
- Physical Form
- Appearance
- Dark amber liquid (at 25°C)
- Dispersible in
- Water
- Soluble in
- Methanol, Xylene
- Insoluble in
- Kerosene
- Typical Properties
Value | Units | Test Method / Conditions | |
Density (at 25°C) | 1.02 | g/ml | — |
Flash Point | 69.4 | °C | PMCC Flash Point Tester |
HLB | 10 | — | — |
Moisture Content | max. 1 | % | — |
pH (5% in 1:1 IPA/H₂O) | 5.7 | — | — |
Pour Point | 8 | °C | — |
Regulated Volatile Organic Chemicals | 25 | % | U.S. EPA |
Viscosity (at 25°C) | 325 | cPs | — |
Regulatory & Compliance
- Certifications & Compliance
- Chemical Inventories
- Clearances
- All components of TOXIMUL 3470F series surfactants are approved for use in the following countries: United States (TSCA), Europe (EINECS/Polymer Exempt), Canada (DSL), Australia (AICS), Philippines (PICCS), China (IECSC), New Zealand (NZloC), and Korea (ECL).
- The TOXIMUL 3470F series are approved for use as inert ingredients under U.S. EPA 40 CFR 180.910 and 180.960, pre- and post-harvest applications.
Packaging & Availability
- Packaging Type
- Standard Packaging
TOXIMUL 3473F is available in drums (450 lb, 205 kg) and in bulk quantities.
Storage & Handling
- Storage & Handling
- Normal safety precautions (i.e. gloves and safety goggles) should be employed when handling TOXIMUL 3470 series. Contact with the eyes and prolonged contact with the skin should be avoided. Wash thoroughly after handling material. Use in a well ventilated area away from sparks and open flame.
- Bulk Storage Information: TOXIMUL 3473F stored in drums at temperatures below 55°F (13°C) may thicken or solidify. They may be fluidized by warming with a drum heater or in a steam room. Drums should be vented prior to heating to avoid excessive pressure build up. Product storage temperatures over 100°F (38°C) are not recommended as excessive solvent loss may occur. The flash point may be exceeded when warming to pump but the temperature should be below the flash point for storage.