Knowde Enhanced TDS
Identification & Functionality
- Agrochemical Functions
- Technologies
Applications & Uses
- Markets
- Applications
TOXIMUL DM-83 series are specially formulated blends of anionic/nonionic surfactants. This series of products can be used as general pesticide emulsifiers and can be paired with each other and with other agricultural emulsifiers for use in an extensive range of pesticides.
Properties
- Formulation Type
- Physical Form
- Appearance
- Hazy, amber liquid (at 40°C)
- Soluble in
- Water, Methanol, Xylene
- Insoluble in
- Kerosene
- Typical Properties
| Value | Units | Test Method / Conditions | |
| Density (at 40°C) | 1.04 | g/ml | — |
| Actives Content | 83 | % | — |
| Flash Point | 65.6 | °C | PMCC Flash Point Tester |
| HLB | 13 | — | — |
| Moisture Content | 0.4 | % | — |
| pH (5% in 1:1 IPA/H₂O) | 6 | — | — |
| Pour Point | max. 15 | °C | — |
| Regulated Volatile Organic Chemicals (Aromatic Naphtha) | 25 | % | U.S. EPA |
| Viscosity (at 40°C) | 135 | cPs | — |
Regulatory & Compliance
- Certifications & Compliance
- Chemical Inventories
- Clearances
- The TOXIMUL DM-83 is approved for use as inert ingredients used pre- and post-harvest. TOXIMUL DH-68 is approved for use under U.S. EPA 40 CFR 180.910.
- Components of TOXIMUL DM-83 are listed in the following countries’ inventories: United States (TSCA), Canada (DSL), Australia (AICS), Europe (EINECS/Polymer), New Zealand (NZIoC), Philippines (PICCS).
- Not approved for use as an inert ingredient in the U.S.
Packaging & Availability
Storage & Handling
- Storage & Handling
- Normal safety precautions (i.e. gloves and safety goggles) should be employed when handling TOXIMUL DM-83 surfactants. Contact with the eyes and prolonged contact with the skin should be avoided. Wash thoroughly after handling materials. Use in a well ventilated area away from sparks and open flames.
- Bulk Storage Information: TOXIMUL DM-83 stored in drums at temperatures below 30°F (-1°C) may thicken or solidify. They may be fluidized by warming with a drum heater or in a steam room. Drums should be vented prior to heating to avoid excessive pressure build up. Product temperatures over 100°F (38°C) are not recommended as excessive solvent loss may occur. The flash point may be exceeded when warming to pump but the temperature should be below the flash point for storage.