Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Plastics & Elastomers Functions
- Technologies
- Product Families
- Composition
Proprietary resin emulsion of polyolefins and fluoropolymer in combination with wetting agents and surfactant in a water vehicle.
Features & Benefits
- Materials Features
Applications & Uses
- Markets
- Compatible Polymers & Resins
- use
Phenolic, Melamine, Rubber Polyester, Epoxy
- Application Instructions
Clean mold with CleanWiz. Apply mold release with a clean cotton cloth wiping in two directions, using a circular motion. Allow to dry for five minutes and hand polish to a smooth finish, wiping straight in two directions. Spray a thin coat (fine mist to dry film) and allow to dry completely with no moisture residue. Accelerate drying time by blowing hot air or by using heat lamps. Repeat whenever mold has been cleaned with CleanWiz or as required to give mold release properties. For best results: Bake release at 300-400ºF for up to 2 hours. This is only necessary for first time application or after cleaning tool. Spray a thin coat as required. Baking is not required after first application but it will improve the mold release properties.
Properties
- Typical Properties
Value | Units | Test Method / Conditions | |
Specific Gravity (25°C) | 0.99 | — | — |
Solids | 11 – 13 | % | — |
pH | 9.5 – 11.5 | — | — |
Flash Point | Non Flammable | — | — |
Viscosity (25°C) | max. 15 | cps | — |
Regulatory & Compliance
- Certifications & Compliance
Storage & Handling
- Shelf Life
- Minimum of one year