Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Plastics & Elastomers Functions
- Technologies
- Product Families
- Composition
Proprietary resin emulsion of polyolefins and organic fatty acids in combination with wetting agents and surfactant in a water vehicle.
Features & Benefits
- Materials Features
Applications & Uses
- Markets
- Applications
- Compatible Polymers & Resins
- Plastics & Elastomers Processing Methods
- Application Method
- Polyester, Epoxy, Acrylic, Methyl methacrylate, Phenolic and Rubber.
- Especially recommended for filament winding/mandrel wrapping and compression molding
- Application Method
Apply to a clean mold surface. If necessary, use Clean Wiz to clean. Depending on the resin and process, mold release can be diluted up to 25 times with luke warm water.(96 Part Water + 4 Part WB-2725) and can be applied by spraying or wiping a thin film on the mold and allowing to dry. For start-up, apply at least 3 light coats allowing each to dry before applying the next coat. Wipe in alternate direction, or if spraying, assure that the spray is light and well distributed on the mold surface. Heat lamps or fans can be used to accelerate drying. Add an additional coat(s) of mold release whenever the mold has been cleaned with Clean Wiz, or as required to restore good release properties.
Properties
- Physical Form
- Typical Properties
Value | Units | Test Method / Conditions | |
Flash Point | Non-Flammable | °F/°C | - |
pH | 9.20 – 11.20 | - | - |
Solids | 20.0 | % | - |
Specific Gravity (25°C) | 1.0 | - | - |
Viscosity at 25°C | max. 50 | cPs | - |
Regulatory & Compliance
- Certifications & Compliance
Packaging & Availability
- Country Availability
- Regional Availability