Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Plastics & Elastomers Functions
- Technologies
Features & Benefits
- Labeling Claims
- Materials Features
- Product Highlights
- Highly effective release performance with fluorocarbon as the principal ingredient. A thin, even film is produced, making it ideal for the release of precision components.
- PFOA and PFOS free* and complies with environmental regulations such as TSCA and RoHS. ≤5ppb detection limit.
- Little transfer, no stickiness left on the mold product.
- Minimal mold contamination is produced, reducing mold -cleaning requirements and improving productivity.
Applications & Uses
- Markets
- Compatible Polymers & Resins
- Applications
Rubbers
SBR, NBR,EPDM,FKM,CR,ACM, etc.
Thermosetting resins
Epoxy, Unsaturated polyester, Phenol, etc.
Thermoplastics
PE, PP, PVC, ABS, etc.
Properties
- Physical Form
- Appearance
- Clear liquid
- Physical Properties
- Note
The above values in properties are representative and not guaranteed.
| Value | Units | Test Method / Conditions | |
| Fire Service Act | Flammable | — | — |
| Principal Solvent | Isooctane | — | — |
| Recommendable Diluting Solvent | Petroleum solvents | — | — |
| Recommendable Dilution Ratio | 1 - 10 times | — | — |
| Solid Component | 3 | mass% | — |
| Specific Gravity (at 25℃) | 0.74 | — | — |
Regulatory & Compliance
- Certifications & Compliance
- Chemical Inventories
Technical Details & Test Data
- Method of Use
Dilution
- Use the agent straight or dilute with recommendable solvent appropriately, and agitate ituntil uniformly mixed.
- Part of the ingredients may settles out when it is used under 15°C. In that case, gradually heat it up to around 25°C .and agitate it before use.
How to apply
- Before using the product for the first time, remove the old release agent completely. Use the steps in ‘(2) Cleaning the mold’ below to clean correctly.
- Apply a uniform coating film using an air spray device or rag.
- When spraying onto a mold, spray the mold release agent lightly with a few passes over the mold.
- It is more effective to apply a few thin coating films of low concentration of the agent than to apply a single thick coating film of high concentration.
- Be sure to use an appropriate amount of the agent since use of an excessive amount may result in mold contamination.
Cleaning the mold
- Slight contamination of the mold release agent can usually be removed to a certain degree by wiping with a solvent (IPA, toluene, acetone).
- Alkaline cleaning agents are effective for complete removal. (Immerse in an approx. 10% aqueous solution of potassium hydroxide or sodium hydroxide to which a small amount of surfactant has been added. The cleaning solution should be at a temperature of 60‐80°C)
Use temperature range
From room temperature to 300
Safety & Health
- Handling / Safety Information
- Be sure to read the Safety Data Sheet (SDS) and precautions on the label before using.
- This product has been developed for industrial purposes and we shall not guarantee the the safety if used for any other purposes. If it is going to be used for medical or food applications, please contact us in advice.
Packaging & Availability
- Package Size
13 Kg