company tower banner

Products

Ebalta Kunststoff Gmbh

4 Products found on Ebalta Kunststoff Gmbh in Aftermarket Parts & Components

Ebalta Kunststoff Gmbh MG 453 GFComp. A + B banner

Ebalta Kunststoff Gmbh MG 453 GFComp. A + B

Polymer Name:Polyurethane (unspecified)
End Uses:Automotive Components, Electronic Data Processing, Modeling Material, Automotive Interior Parts, Automotive Exterior Parts
Density:1180.0 - 1220.0 kg/m³

Ebalta MG 453 GF is processed on a two-component low pressure device. After grinding with a sand paper , grit 280, the surface can be varnished with a commercial lacquer. For better adhesion we recommend the use of a primer coat. Release agent – please see category release agent

Ebalta Kunststoff Gmbh MG 425PUR 19 banner

Ebalta Kunststoff Gmbh MG 425PUR 19

Polymer Name:Polyurethane (unspecified)
Processing Methods:Injection Molding, Casting, Reaction Injection Molding (RIM)
End Uses:Automotive Components, Modeling Material, Automotive Interior Parts, Electronic Data Processing, Automotive Exterior Parts
Density:1130.0 - 1170.0 kg/m³

ebalta MG 425 is processed on a two-component low pressure device. The systems MG 400 / MG 425 / MG 475 are cured with the hardener PUR 19. By mixing MG 425 with MG 400 the E-modulus can variably between 630 – 1550 MPa. After grinding with a sand paper , grit 280, the surface can be varnished with a commercial lacquer. For better adhesion we recommend the use of a primer coat. Nitrocellulose lacquers have a better adhesion on polyurethane surfaces than on acryllacquer- systems. Release agent – please see category release agent

Ebalta Kunststoff Gmbh MG 426Comp. A + B banner

Ebalta Kunststoff Gmbh MG 426Comp. A + B

Polymer Name:Polyurethane (unspecified)
Processing Methods:Casting
End Uses:Automotive Components, Modeling Material, Automotive Interior Parts, Electronic Data Processing, Automotive Exterior Parts
Density:1150.0 - 1190.0 kg/m³
Tensile Strength:48.0 - 58.0 MPa

ebalta MG 426 is processed on a two-component low pressure device. After grinding with a sand paper , grit 280, the surface can be varnished with a commercial lacquer. For better adhesion we recommend the use of a primer coat. Nitrocellulose lacquers have a better adhesion on polyurethane surfaces than on acryl-lacquer- systems. Release agent – please see category release agent.

Ebalta Kunststoff Gmbh MG 453Comp. A+B banner

Ebalta Kunststoff Gmbh MG 453Comp. A+B

Polymer Name:Polyurethane (unspecified)
Processing Methods:Injection Molding, Casting, Reaction Injection Molding (RIM)
End Uses:Automotive Components, Modeling Material, Automotive Interior Parts, Electronic Data Processing, Automotive Exterior Parts
Density:1170.0 - 1210.0 kg/m³

ebalta MG 453 is processed on a two-component low pressure device. After grinding with a sand paper , grit 280, the surface can be varnished with a commercial lacquer. For better adhesion we recommend the use of a primer coat. Release agent – please see category release agent