Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
- Product Families
Features & Benefits
Applications & Uses
- Markets
- Applications
- Application Area
- Instruction for Use
- Mix EC-1012M thoroughly each time before removing material.
- To each 100 grams of EC-1012M, add 10 grams of Hardener EH-20M and mix it well preferably using a mechanical mixer.
- Vacuum degasses for about five minutes to remove any dissolved or entrapped air.
- Proceed with the casting or potting application and cure as recommended.
- Industrial Usage
These materials are intended for industrial use only, and the practices of good housekeeping, safety and cleanliness should be followed before, during and after use.
Properties
- Color
- Typical Properties
- Typical Cured Properties
| Value | Units | Test Method / Conditions | |
| Mixed Viscocity | 3000 - 6000 | cPs | — |
| Pot Life (at 25°C, 500g) | 4 - 5 | hours | — |
| Recommended Cure (at 65°C) | 3 | hours | — |
| Recommended Cure (at 130°C) | 1 | hours | — |
| Alternate Cure (at 25°C) | 24 - 48 | hours | — |
| Value | Units | Test Method / Conditions | |
| Specific Giravity | 1.7 | — | — |
| Hardness | 91 | Shore D | — |
| Linear Shrinkage | 0 | % | — |
| Water Absorption (24 hr at Room Temperature) | 0.1 | % | — |
| Thermal Conductivity | 0.9 | W/m °K | — |
| Service Temperature Range | 40 to 160 | °C | — |
| Glass Transition Temperature (Tg) | 85 | °C | — |
| Coefficient of Thermal Expansion (Below Tg) | 38 | 10^-6/°C | — |
| Flexural Strength | 14800 | psi | — |
| Flexural Modulus | 7x10^5 | psi | — |
| Dielectric Strength | 410 | Volts/mil | — |
| Dielectric Constant (at 1 kHz) | 5.5 | — | — |
| Dissipation Factor (at 1 kHz) | 0.021 | — | — |
| Volume Resistivity | 1.0x10^15 | Ω-cm | — |
Regulatory & Compliance
- Certifications & Compliance
Safety & Health
- Warning
Although the system contains low volatility materials, care should be taken in handling. Adequate ventilation of work place and ovens is essential. These materials may cause injury to the skin following prolonged or repeated contact and dermatitis in susceptible individuals. In case of skin contact, wash thoroughly with soap and water. For eyes, flush immediately with plenty of water for at least 10 minutes and seek medical attention.
Storage & Handling
- Shelf Life
The shelf life of these materials is greater than one year when stored in unopened containers at an average temperature of 25°C.