Knowde Enhanced TDS
Identification & Functionality
- Chemical Family
- Technologies
- Product Families
Features & Benefits
- Ready-to-Use Product Features
- Product Features
Fast setting, polyurethane potting compound designed for potting battery packs, controllers, and coil windings.
Applications & Uses
- Markets
- Applications
- Product Applications
The cured elastomer has excellent water resistance and is exceptionally resistant to thermal shock. It is useful for general purpose casting, potting or encapsulating intricate circuits, operational amplifiers, transformers, and other electric/electronic components.
- Instruction for Use
1. Mix contents thoroughly each time before removing material.
2. To each 15 grams of Part A, add 100 grams of Part B and mix it well preferably using a mechanical mixer.
3. Vacuum degas to remove any dissolved or entrapped air.
4. Proceed with the casting or potting application and cure as recommended.- Industrial Usage
These materials are intended for industrial use only, and the practices of good housekeeping, safety and cleanliness should be followed before, during and after use.
Properties
- Component A
- Typical Properties
- Component B
- Typical Cured Properties
| Value | Units | Test Method / Conditions | |
| Density (at 25°C, PART-A) | 1.22 | cPs | — |
| Value | Units | Test Method / Conditions | |
| Mix Ratio by Weight (A:B) | 15/100 | — | — |
| Mixed Density (at 25°C) | 1.57 | — | — |
| Viscosity (at 25°C, PART-A) | 65 - 85 | cPs | — |
| Viscosity (at 25°C, PART-B) | 15,000 - 30,000 | cPs | — |
| Mixed Viscocity (at 25°C) | 4000 - 8000 | cPs | — |
| Gel Time (at 25°C, 115g) | 8 - 12 | minutes | — |
| Recommended Cure Schedule (at 25°C) | 8 - 24 | hours | — |
| Recommended Cure Schedule (65°C) | 30 | minutes | — |
| Value | Units | Test Method / Conditions | |
| Density (at 25°C, PART-B) | 1.6 | cPs | — |
| Value | Units | Test Method / Conditions | |
| Specific Gravity | 1.56 | — | — |
| Hardness | 88 | Shore A | — |
| Water Absorption (24 hr at Room Temperature) | 0.15 | % | — |
| Weight Loss (at 120°C, 7 days) | 0.2 | % | — |
| Service Temperature Range | -55 to 110 | °C | — |
| Dielectric Strength (0.125 inch) | 420 | Volts/mil | — |
| Dielectric Constant (at 1 kHz) | 4.2 | — | — |
| Dissipation Factor (at 1 kHz) | 0.02 | — | — |
| Volume Resistivity | 2x10^14 | Ω-cm | — |
Regulatory & Compliance
- Certifications & Compliance
Safety & Health
- Warning
Although the system contains low volatility materials, care should be taken in handling. Adequate ventilation of workplace and ovens is essential. These materials may cause injury to the skin following prolonged or repeated contact and dermatitis in susceptible individuals. In case of skin contact, wash thoroughly with soap and water. For eyes, flush immediately with plenty of water for at least 10 minutes and seek medical attention.
Storage & Handling
- Shelf Life
- 12 Months
- Shelf Life
The shelf life of these materials is 12 months when stored in unopened containers at an average temperature of 25°C. If containers are opened and the contents only partially used, the container should be flushed with dry nitrogen before being resealed.